lkml.org 
[lkml]   [2018]   [Mar]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH AUTOSEL for 4.14 01/67] Bluetooth: hci_qca: Avoid setup failure on missing rampatch
Date
From: Loic Poulain <loic.poulain@linaro.org>

[ Upstream commit ba8f3597900291a93604643017fff66a14546015 ]

Assuming that the original code idea was to enable in-band sleeping
only if the setup_rome method returns succes and run in 'standard'
mode otherwise, we should not return setup_rome return value which
makes qca_setup fail if no rampatch/nvm file found.

This fixes BT issue on the dragonboard-820C p4 which includes the
following QCA controller:
hci0: Product:0x00000008
hci0: Patch :0x00000111
hci0: ROM :0x00000302
hci0: SOC :0x00000044

Since there is no rampatch for this controller revision, just make
it work as is.

Signed-off-by: Loic Poulain <loic.poulain@linaro.org>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
Signed-off-by: Sasha Levin <alexander.levin@microsoft.com>
---
drivers/bluetooth/hci_qca.c | 3 +++
1 file changed, 3 insertions(+)

diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 392f412b4575..c9f0ac083a3e 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -933,6 +933,9 @@ static int qca_setup(struct hci_uart *hu)
if (!ret) {
set_bit(STATE_IN_BAND_SLEEP_ENABLED, &qca->flags);
qca_debugfs_init(hdev);
+ } else if (ret == -ENOENT) {
+ /* No patch/nvm-config found, run with original fw/config */
+ ret = 0;
}

/* Setup bdaddr */
--
2.14.1
\
 
 \ /
  Last update: 2018-03-08 07:53    [W:0.257 / U:0.264 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site