lkml.org 
[lkml]   [2018]   [Mar]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectRe: call/normal switch was Re: omap4-droid4: voice call support was
    * Pavel Machek <pavel@ucw.cz> [180331 19:56]:
    > On Sat 2018-03-31 21:46:16, Pavel Machek wrote:
    > > On Sat 2018-03-31 21:19:39, Pavel Machek wrote:
    > > > On Sat 2018-03-31 11:19:35, Tony Lindgren wrote:
    > > > > Cool :) Microphone still does not work for me.. I tried tweaking
    > > > > the alsamixer settings but no mic. This is with cold boot with
    > > > > droid4-kexecboot if that might make a difference, we may have
    > > > > some register uninitialized somewhere. Any ideas?
    > > >
    > > > Ok, I was focusing on the speaker side.
    > > >
    > > > alsamixer, tab to go to capture settings, set it to 37 37 Mic2 Mic1
    > > > should work, according to my notes, but not recently tested and not
    > > > tested against real human.
    > > >
    > > > I'll attempt to test it, but something in my userland shuts down
    > > > system just after boot 60% of time, which is rather annoying.
    > >
    > > Hmm. So I tried again, and setting Mic1 and back in the capture
    > > settings crashed the modem. Bang, disconnected from the USB.
    >
    > Next try, and it worked this time.
    >
    > _Before the call_, set mode to Normal and then Call. Then go to
    > capture, and set 100 100 Mic2 Mic1. Then place a call,
    >
    > AT+CFUN=1
    > OK
    > ATD6;

    No luck with microphone here :( Using ttyUSB4, AT+CFUN=1
    works, but ATD command on it just hangs the USB interface
    and I have to reload phy-mapphone-mdm6600 to reset the
    modem.

    > If you change Mic1 setting, GSM modem will likely crash.

    Have not seen that one here :)

    Regards,

    Tony

    \
     
     \ /
      Last update: 2018-04-01 01:44    [W:2.548 / U:0.096 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site