lkml.org 
[lkml]   [2018]   [Mar]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 4/4] gpio: Remove VLA from stmpe driver
From
Date
On 03/13/2018 05:18 PM, Laura Abbott wrote:
> On 03/13/2018 02:13 AM, Phil Reid wrote:
>> On 10/03/2018 08:10, Laura Abbott wrote:
>>> The new challenge is to remove VLAs from the kernel
>>> (see https://lkml.org/lkml/2018/3/7/621)
>>>
>>> This patch replaces a VLA with an appropriate call to kmalloc_array.
>>>
>>> Signed-off-by: Laura Abbott <labbott@redhat.com>
>>> ---
>>>   drivers/gpio/gpio-stmpe.c | 7 ++++++-
>>>   1 file changed, 6 insertions(+), 1 deletion(-)
>>>
>>> diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
>>> index f8d7d1cd8488..b7854850bcdb 100644
>>> --- a/drivers/gpio/gpio-stmpe.c
>>> +++ b/drivers/gpio/gpio-stmpe.c
>>> @@ -369,10 +369,14 @@ static irqreturn_t stmpe_gpio_irq(int irq, void *dev)
>>>       struct stmpe *stmpe = stmpe_gpio->stmpe;
>>>       u8 statmsbreg;
>>>       int num_banks = DIV_ROUND_UP(stmpe->num_gpios, 8);
>>> -    u8 status[num_banks];
>>> +    u8 *status;
>>>       int ret;
>>>       int i;
>>> +    status = kmalloc_array(num_banks, sizeof(*status), GFP_ATOMIC);
>>> +    if (!status)
>>> +        return IRQ_NONE;
>>> +
>>>       /*
>>>        * the stmpe_block_read() call below, imposes to set statmsbreg
>>>        * with the register located at the lowest address. As STMPE1600
>>> @@ -424,6 +428,7 @@ static irqreturn_t stmpe_gpio_irq(int irq, void *dev)
>>>           }
>>>       }
>>> +    kfree(status);
>>>       return IRQ_HANDLED;
>>>   }
>>>
>>
>> Doing this in an irq handler seems wrong.
>> Perhaps better if a buffer is pre-allocated in stmpe_gpio
>>
>>
>
> Sure, I can pre-allocate the buffer in the probe.
>
> Thanks,
> Laura

Actually I wonder if there would be concurrency problems if we
tried to pre-allocate a global buffer. But the IRQ handler
calls stmpe_block_read which takes a mutex to sleep so I think
doing the (small) kmalloc should be fine and I can change it to
a GFP_KERNEL.

Thanks,
Laura

\
 
 \ /
  Last update: 2018-03-14 02:18    [W:0.076 / U:0.144 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site