lkml.org 
[lkml]   [2018]   [Feb]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 05/15] ARM: dts: dra76-evm: Add pinctrl data for higher speed MMC/SD modes
Date
From: Sekhar Nori <nsekhar@ti.com>

The SD card interface on DRA76x EVM can support
high speed SD cards. The eMMC onboard can support
upto HS200 mode.

Enable support for these higher speed modes in the
device-tree file.

Signed-off-by: Sekhar Nori <nsekhar@ti.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
---
arch/arm/boot/dts/dra76-evm.dts | 8 ++++++--
1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/dra76-evm.dts b/arch/arm/boot/dts/dra76-evm.dts
index 70854be0ce6a..088853001c81 100644
--- a/arch/arm/boot/dts/dra76-evm.dts
+++ b/arch/arm/boot/dts/dra76-evm.dts
@@ -314,16 +314,20 @@
* is always hardwired.
*/
cd-gpios = <&gpio6 27 GPIO_ACTIVE_LOW>;
- pinctrl-names = "default";
+ pinctrl-names = "default", "hs";
pinctrl-0 = <&mmc1_pins_default>;
+ pinctrl-1 = <&mmc1_pins_hs>;
};

&mmc2 {
status = "okay";
vmmc-supply = <&vio_1v8>;
bus-width = <8>;
- pinctrl-names = "default";
+ pinctrl-names = "default", "hs", "ddr_1_8v", "hs200_1_8v";
pinctrl-0 = <&mmc2_pins_default>;
+ pinctrl-1 = <&mmc2_pins_default>;
+ pinctrl-2 = <&mmc2_pins_default>;
+ pinctrl-3 = <&mmc2_pins_hs200 &mmc2_iodelay_hs200_conf>;
};

/* No RTC on this device */
--
2.11.0
\
 
 \ /
  Last update: 2018-02-06 14:04    [W:0.131 / U:7.944 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site