lkml.org 
[lkml]   [2018]   [Feb]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 1/1] x86: Fix Intel Edison module stuck reboot
Date
When powering Intel Edison module with 3.3V, the "reboot" command makes
the module stuck.
If the module is powered at a greater voltage, like 4.4V (as the Edison
Mini Breakout board does), reboot works OK.

This patch copies the behaviour from the official Intel Edison BSP,
where "IPCMSG_COLD_RESET" message was sent to SCU by default at
reboot time.

In the official BSP, sending the "IPCMSG_COLD_BOOT" message instead of
"IPCMSG_COLD_RESET" was possible, by using a kernel command
line parameter.

Signed-off-by: Sebastian Panceac <sebastian@resin.io>
---

Hi,

I submitted again the patch, after taking into consideration Andy's suggestions.

Regards!

arch/x86/platform/intel-mid/intel-mid.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/x86/platform/intel-mid/intel-mid.c b/arch/x86/platform/intel-mid/intel-mid.c
index 2c67bae..fb1df94 100644
--- a/arch/x86/platform/intel-mid/intel-mid.c
+++ b/arch/x86/platform/intel-mid/intel-mid.c
@@ -79,7 +79,7 @@ static void intel_mid_power_off(void)

static void intel_mid_reboot(void)
{
- intel_scu_ipc_simple_command(IPCMSG_COLD_BOOT, 0);
+ intel_scu_ipc_simple_command(IPCMSG_COLD_RESET, 0);
}

static unsigned long __init intel_mid_calibrate_tsc(void)
--
2.7.4
\
 
 \ /
  Last update: 2018-02-28 10:41    [W:0.060 / U:0.552 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site