lkml.org 
[lkml]   [2018]   [Feb]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH v2] iio: chemical: ccs811: Corrected firmware boot/application mode transition
On Sat, 17 Feb 2018 16:28:24 +0000
Richard Lai <richard@richardman.com> wrote:

> CCS811 has different I2C register maps in boot and application mode. When
> CCS811 is in boot mode, register APP_START (0xF4) is used to transit the
> firmware state from boot to application mode. However, APP_START is not a
> valid register location when CCS811 is in application mode (refer to
> "CCS811 Bootloader Register Map" and "CCS811 Application Register Map" in
> CCS811 datasheet). The driver should not attempt to perform a write to
> APP_START while CCS811 is in application mode, as this is not a valid or
> documented register location.
>
> When prob function is being called, the driver assumes the CCS811 sensor
> is in boot mode, and attempts to perform a write to APP_START. Although
> CCS811 powers-up in boot mode, it may have already been transited to
> application mode by previous instances, e.g. unload and reload device
> driver by the system, or explicitly by user. Depending on the system
> design, CCS811 sensor may be permanently connected to system power source
> rather than power controlled by GPIO, hence it is possible that the sensor
> is never power reset, thus the firmware could be in either boot or
> application mode at any given time when driver prob function is being
> called.
>
> This patch checks the STATUS register before attempting to send a write to
> APP_START. Only if the firmware is not in application mode and has valid
> firmware application loaded, then it will continue to start transiting the
> firmware boot to application mode.
>
> Signed-off-by: Richard Lai <richard@richardman.com>
Applied to the fixes-togreg branch of iio.git and marked for stable.

Thanks,

Jonathan

> ---
> Changes in v2:
> - Removed unnecessary macros introduced in previous patch
>
> drivers/iio/chemical/ccs811.c | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/drivers/iio/chemical/ccs811.c b/drivers/iio/chemical/ccs811.c
> index 840a6cb..6ad8a42 100644
> --- a/drivers/iio/chemical/ccs811.c
> +++ b/drivers/iio/chemical/ccs811.c
> @@ -129,6 +129,9 @@ static int ccs811_start_sensor_application(struct i2c_client *client)
> if (ret < 0)
> return ret;
>
> + if ((ret & CCS811_STATUS_FW_MODE_APPLICATION))
> + return 0;
> +
> if ((ret & CCS811_STATUS_APP_VALID_MASK) !=
> CCS811_STATUS_APP_VALID_LOADED)
> return -EIO;

\
 
 \ /
  Last update: 2018-02-24 13:14    [W:1.124 / U:0.060 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site