lkml.org 
[lkml]   [2018]   [Feb]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 3/3] mm/sparse: Optimize memmap allocation during sparse_init()
Hi Pankaj,

On 02/22/18 at 05:07am, Pankaj Gupta wrote:
>
> Hi Baoquan,
>
> >
> > In sparse_init(), two temporary pointer arrays, usemap_map and map_map
> > are allocated with the size of NR_MEM_SECTIONS. They are used to store
> > each memory section's usemap and mem map if marked as present. With
> > the help of these two arrays, continuous memory chunk is allocated for
> > usemap and memmap for memory sections on one node. This avoids too many
> > memory fragmentations. Like below diagram, '1' indicates the present
> > memory section, '0' means absent one. The number 'n' could be much
> > smaller than NR_MEM_SECTIONS on most of systems.
> >
> > |1|1|1|1|0|0|0|0|1|1|0|0|...|1|0||1|0|...|1||0|1|...|0|
> > -------------------------------------------------------
> > 0 1 2 3 4 5 i i+1 n-1 n
> >
> > If fail to populate the page tables to map one section's memmap, its
> > ->section_mem_map will be cleared finally to indicate that it's not present.
> > After use, these two arrays will be released at the end of sparse_init().
> >
> > In 4-level paging mode, each array costs 4M which can be ignorable. While
> > in 5-level paging, they costs 256M each, 512M altogether. Kdump kernel
> > Usually only reserves very few memory, e.g 256M. So, even thouth they are
> > temporarily allocated, still not acceptable.
> >
> > In fact, there's no need to allocate them with the size of NR_MEM_SECTIONS.
> > Since the ->section_mem_map clearing has been deferred to the last, the
> > number of present memory sections are kept the same during sparse_init()
> > until we finally clear out the memory section's ->section_mem_map if its
> > usemap or memmap is not correctly handled. Thus in the middle whenever
> > for_each_present_section_nr() loop is taken, the i-th present memory
> > section is always the same one.
> >
> > Here only allocate usemap_map and map_map with the size of
> > 'nr_present_sections'. For the i-th present memory section, install its
> > usemap and memmap to usemap_map[i] and mam_map[i] during allocation. Then
> > in the last for_each_present_section_nr() loop which clears the failed
> > memory section's ->section_mem_map, fetch usemap and memmap from
> > usemap_map[] and map_map[] array and set them into mem_section[]
> > accordingly.
> >
> > Signed-off-by: Baoquan He <bhe@redhat.com>
> >
> > Signed-off-by: Baoquan He <bhe@redhat.com>
> > ---
> > mm/sparse-vmemmap.c | 8 +++++---
> > mm/sparse.c | 40 ++++++++++++++++++++++++++--------------
> > 2 files changed, 31 insertions(+), 17 deletions(-)
> >
> > diff --git a/mm/sparse-vmemmap.c b/mm/sparse-vmemmap.c
> > index 640e68f8324b..f83723a49e47 100644
> > --- a/mm/sparse-vmemmap.c
> > +++ b/mm/sparse-vmemmap.c
> > @@ -281,6 +281,7 @@ void __init sparse_mem_maps_populate_node(struct page
> > **map_map,
> > unsigned long pnum;
> > unsigned long size = sizeof(struct page) * PAGES_PER_SECTION;
> > void *vmemmap_buf_start;
> > + int i = 0;
> >
> > size = ALIGN(size, PMD_SIZE);
> > vmemmap_buf_start = __earlyonly_bootmem_alloc(nodeid, size * map_count,
> > @@ -291,14 +292,15 @@ void __init sparse_mem_maps_populate_node(struct page
> > **map_map,
> > vmemmap_buf_end = vmemmap_buf_start + size * map_count;
> > }
> >
> > - for (pnum = pnum_begin; pnum < pnum_end; pnum++) {
> > + for (pnum = pnum_begin; pnum < pnum_end && i < map_count; pnum++) {
> > struct mem_section *ms;
> >
> > if (!present_section_nr(pnum))
> > continue;
> >
> > - map_map[pnum] = sparse_mem_map_populate(pnum, nodeid, NULL);
> > - if (map_map[pnum])
> > + i++;
> > + map_map[i-1] = sparse_mem_map_populate(pnum, nodeid, NULL);
> > + if (map_map[i-1])
> > continue;
> > ms = __nr_to_section(pnum);
> > pr_err("%s: sparsemem memory map backing failed some memory will not be
> > available\n",
> > diff --git a/mm/sparse.c b/mm/sparse.c
> > index e9311b44e28a..aafb6d838872 100644
> > --- a/mm/sparse.c
> > +++ b/mm/sparse.c
> > @@ -405,6 +405,7 @@ static void __init sparse_early_usemaps_alloc_node(void
> > *data,
> > unsigned long pnum;
> > unsigned long **usemap_map = (unsigned long **)data;
> > int size = usemap_size();
> > + int i = 0;
> >
> > usemap = sparse_early_usemaps_alloc_pgdat_section(NODE_DATA(nodeid),
> > size * usemap_count);
> > @@ -413,12 +414,13 @@ static void __init sparse_early_usemaps_alloc_node(void
> > *data,
> > return;
> > }
> >
> > - for (pnum = pnum_begin; pnum < pnum_end; pnum++) {
> > + for (pnum = pnum_begin; pnum < pnum_end && i < usemap_count; pnum++) {
> > if (!present_section_nr(pnum))
> > continue;
> > - usemap_map[pnum] = usemap;
> > + usemap_map[i] = usemap;
> > usemap += size;
> > - check_usemap_section_nr(nodeid, usemap_map[pnum]);
> > + check_usemap_section_nr(nodeid, usemap_map[i]);
> > + i++;
> > }
> > }
> >
> > @@ -447,14 +449,17 @@ void __init sparse_mem_maps_populate_node(struct page
> > **map_map,
> > void *map;
> > unsigned long pnum;
> > unsigned long size = sizeof(struct page) * PAGES_PER_SECTION;
> > + int i;
> >
> > map = alloc_remap(nodeid, size * map_count);
> > if (map) {
> > - for (pnum = pnum_begin; pnum < pnum_end; pnum++) {
> > + i = 0;
> > + for (pnum = pnum_begin; pnum < pnum_end && i < map_count; pnum++) {
> > if (!present_section_nr(pnum))
> > continue;
> > - map_map[pnum] = map;
> > + map_map[i] = map;
> > map += size;
> > + i++;
> > }
> > return;
> > }
> > @@ -464,23 +469,27 @@ void __init sparse_mem_maps_populate_node(struct page
> > **map_map,
> > PAGE_SIZE, __pa(MAX_DMA_ADDRESS),
> > BOOTMEM_ALLOC_ACCESSIBLE, nodeid);
> > if (map) {
> > - for (pnum = pnum_begin; pnum < pnum_end; pnum++) {
> > + i = 0;
> > + for (pnum = pnum_begin; pnum < pnum_end && i < map_count; pnum++) {
> > if (!present_section_nr(pnum))
> > continue;
> > - map_map[pnum] = map;
> > + map_map[i] = map;
> > map += size;
> > + i++;
> > }
> > return;
> > }
> >
> > /* fallback */
> > - for (pnum = pnum_begin; pnum < pnum_end; pnum++) {
> > + i = 0;
> > + for (pnum = pnum_begin; pnum < pnum_end && i < map_count; pnum++) {
> > struct mem_section *ms;
> >
> > if (!present_section_nr(pnum))
> > continue;
> > - map_map[pnum] = sparse_mem_map_populate(pnum, nodeid, NULL);
> > - if (map_map[pnum])
> > + i++;
> > + map_map[i-1] = sparse_mem_map_populate(pnum, nodeid, NULL);
> > + if (map_map[i-1])
> > continue;
>
> Below statement will look better?
>
> map_map[i] = sparse_mem_map_populate(pnum, nodeid, NULL);
> if (map_map[i++])
> continue;

Thanks for reviewing.

It looks similar trick as the used in patch. If no other input about
this, I will update with your suggestion. And other places too.

Thanks
Baoquan

>
>
> > ms = __nr_to_section(pnum);
> > pr_err("%s: sparsemem memory map backing failed some memory will not be
> > available\n",
> > @@ -558,6 +567,7 @@ static void __init alloc_usemap_and_memmap(void
> > (*alloc_func)
> > /* new start, update count etc*/
> > nodeid_begin = nodeid;
> > pnum_begin = pnum;
> > + data += map_count;
> > map_count = 1;
> > }
> > /* ok, last chunk */
> > @@ -576,6 +586,7 @@ void __init sparse_init(void)
> > unsigned long *usemap;
> > unsigned long **usemap_map;
> > int size;
> > + int i = 0;
> > #ifdef CONFIG_SPARSEMEM_ALLOC_MEM_MAP_TOGETHER
> > int size2;
> > struct page **map_map;
> > @@ -598,7 +609,7 @@ void __init sparse_init(void)
> > * powerpc need to call sparse_init_one_section right after each
> > * sparse_early_mem_map_alloc, so allocate usemap_map at first.
> > */
> > - size = sizeof(unsigned long *) * NR_MEM_SECTIONS;
> > + size = sizeof(unsigned long *) * nr_present_sections;
> > usemap_map = memblock_virt_alloc(size, 0);
> > if (!usemap_map)
> > panic("can not allocate usemap_map\n");
> > @@ -606,7 +617,7 @@ void __init sparse_init(void)
> > (void *)usemap_map);
> >
> > #ifdef CONFIG_SPARSEMEM_ALLOC_MEM_MAP_TOGETHER
> > - size2 = sizeof(struct page *) * NR_MEM_SECTIONS;
> > + size2 = sizeof(struct page *) * nr_present_sections;
> > map_map = memblock_virt_alloc(size2, 0);
> > if (!map_map)
> > panic("can not allocate map_map\n");
> > @@ -617,14 +628,15 @@ void __init sparse_init(void)
> > for_each_present_section_nr(0, pnum) {
> > struct mem_section *ms;
> > ms = __nr_to_section(pnum);
> > - usemap = usemap_map[pnum];
> > + i++;
> > + usemap = usemap_map[i-1];
>
> Can try same as above and other places where possible
>
> > if (!usemap) {
> > ms->section_mem_map = 0;
> > continue;
> > }
> >
> > #ifdef CONFIG_SPARSEMEM_ALLOC_MEM_MAP_TOGETHER
> > - map = map_map[pnum];
> > + map = map_map[i-1];
> > #else
> > map = sparse_early_mem_map_alloc(pnum);
> > #endif
> > --
> > 2.13.6
> >
> > --
> > To unsubscribe, send a message with 'unsubscribe linux-mm' in
> > the body to majordomo@kvack.org. For more info on Linux MM,
> > see: http://www.linux-mm.org/ .
> > Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>
> >

\
 
 \ /
  Last update: 2018-02-22 11:40    [W:0.113 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site