lkml.org 
[lkml]   [2018]   [Dec]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v1 1/3] of: add nvidia,thermtrips property
Date
Add optional property "nvidia,thermtrips".
If present, these trips will be used as HW shutdown trips,
and critical trips will be used as SW shutdown trips.

Signed-off-by: Wei Ni <wni@nvidia.com>
---
.../bindings/thermal/nvidia,tegra124-soctherm.txt | 20 +++++++++++++++++---
1 file changed, 17 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/thermal/nvidia,tegra124-soctherm.txt b/Documentation/devicetree/bindings/thermal/nvidia,tegra124-soctherm.txt
index b6c0ae53d4dc..ab66d6feab4b 100644
--- a/Documentation/devicetree/bindings/thermal/nvidia,tegra124-soctherm.txt
+++ b/Documentation/devicetree/bindings/thermal/nvidia,tegra124-soctherm.txt
@@ -55,10 +55,21 @@ Required properties :
- #cooling-cells: Should be 1. This cooling device only support on/off state.
See ./thermal.txt for a description of this property.

+Optional properties:
+- nvidia,thermtrips : When present, this property specifies the temperature at
+ which the soctherm hardware will assert the thermal trigger signal to the
+ Power Management IC, which can be configured to reset or shutdown the device.
+ It is an array of pairs where each pair represents a tsensor id followed by a
+ temperature in milli Celcius. In the absence of this property the critical
+ trip point will be used for thermtrip temperature.
+
Note:
-- the "critical" type trip points will be set to SOC_THERM hardware as the
-shut down temperature. Once the temperature of this thermal zone is higher
-than it, the system will be shutdown or reset by hardware.
+- the "critical" type trip points will be used to set the temperature at which
+the SOC_THERM hardware will assert a thermal trigger if the "nvidia,thermtrips"
+property is missing. When the thermtrips property is present, the breach of a
+critical trip point is reported back to the thermal framework to implement
+software shutdown.
+
- the "hot" type trip points will be set to SOC_THERM hardware as the throttle
temperature. Once the the temperature of this thermal zone is higher
than it, it will trigger the HW throttle event.
@@ -79,6 +90,9 @@ Example :

#thermal-sensor-cells = <1>;

+ nvidia,thermtrips = <TEGRA124_SOCTHERM_SENSOR_CPU 102500
+ TEGRA124_SOCTHERM_SENSOR_GPU 103000>;
+
throttle-cfgs {
/*
* When the "heavy" cooling device triggered,
--
2.7.4
\
 
 \ /
  Last update: 2018-12-07 11:15    [W:0.060 / U:0.020 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site