lkml.org 
[lkml]   [2018]   [Dec]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Date
SubjectRe: [PATCH 1/3] ARM: dts: imx6qdl-sabresd: add light sensor support
Hi Anson,

On Wed, Dec 5, 2018 at 7:20 AM Anson Huang <anson.huang@nxp.com> wrote:
>
> Add isl29023 light sensor support on i2c3 bus, the light
> sensor's power is controlled by a fixed regulator, since
> the isl29023 driver and most of other sensors on same
> board like mag3110 and mma8451 do NOT support regulator
> operation currently, they are all controlled by this
> regulator, so this patch also adds the fixed regulator
> support and make it always on.
>
> Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
> ---
> arch/arm/boot/dts/imx6qdl-sabresd.dtsi | 34 ++++++++++++++++++++++++++++++++++
> 1 file changed, 34 insertions(+)
>
> diff --git a/arch/arm/boot/dts/imx6qdl-sabresd.dtsi b/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
> index d7389b5..f96ae54 100644
> --- a/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
> +++ b/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
> @@ -62,6 +62,19 @@
> gpio = <&gpio3 19 0>;
> enable-active-high;
> };
> +
> + reg_sensor: regulator@4 {

I know that you followed the existing pattern for regulators in this
file, but it is not recommended to put regulators under "simple-bus".

I would suggest you to make a first patch of the series that removes
all of the existing regulators from "simple-bus", then you add this
series on top.

Then this regulator becomes:

reg_light_sensor: regulator-light-sensor {

> + compatible = "regulator-fixed";
> + reg = <4>;
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_sensor_reg>;

pinctrl_sensor_reg is too generic. You could use pinctrl_light_sensor_reg

> + regulator-name = "sensor-supply";
> + regulator-min-microvolt = <3300000>;
> + regulator-max-microvolt = <3300000>;
> + gpio = <&gpio2 31 GPIO_ACTIVE_HIGH>;
> + enable-active-high;
> + regulator-always-on;
> + };
> };
>
> gpio-keys {
> @@ -420,6 +433,15 @@
> interrupts = <7 2>;
> wakeup-gpios = <&gpio6 7 0>;
> };
> +
> + isl29023@44 {

Node names should be generic, so: light-sensor@44

\
 
 \ /
  Last update: 2018-12-05 13:15    [W:0.070 / U:0.304 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site