lkml.org 
[lkml]   [2018]   [Dec]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 1/7] spi: add support for octo mode I/O data transfer
Hi Yogesh,

On Thu, 22 Nov 2018 05:14:31 +0000
Yogesh Narayan Gaur <yogeshnarayan.gaur@nxp.com> wrote:

> Add flags for Octo mode I/O data transfer
> Required for the SPI controller which can do the data transfer (TX/RX)
> on 8 data lines e.g. NXP FlexSPI controller.
> SPI_TX_OCTO: transmit with 8 wires
> SPI_RX_OCTO: receive with 8 wires
>
> Signed-off-by: Yogesh Gaur <yogeshnarayan.gaur@nxp.com>
> Reviewed-by: Boris Brezillon <boris.brezillon@bootlin.com>
> ---
> Changes for v4:
> - Rebase on top of v4.20-rc2
> Changes for v3:
> - Modified string 'octal' with 'octo'.

When I listed the differences between your version and mine, I
mentioned the OCTO vs OCTAL name, but I didn't say my decision was the
correct one :-). Looks like OCTAL is the term employed almost
everywhere, and it's also consistent with DUAL. Would you mind
sending a new version reverting the name to OCTAL.

Sorry for the unclear statement in my previous review.

Regards,

Boris

\
 
 \ /
  Last update: 2018-12-03 09:07    [W:0.105 / U:0.104 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site