lkml.org 
[lkml]   [2018]   [Nov]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4.19 058/110] can: hi311x: Use level-triggered interrupt
Date
4.19-stable review patch.  If anyone has any objections, please let me know.

------------------

From: Lukas Wunner <lukas@wunner.de>

commit f164d0204b1156a7e0d8d1622c1a8d25752befec upstream.

If the hi3110 shares the SPI bus with another traffic-intensive device
and packets are received in high volume (by a separate machine sending
with "cangen -g 0 -i -x"), reception stops after a few minutes and the
counter in /proc/interrupts stops incrementing. Bus state is "active".
Bringing the interface down and back up reconvenes the reception. The
issue is not observed when the hi3110 is the sole device on the SPI bus.

Using a level-triggered interrupt makes the issue go away and lets the
hi3110 successfully receive 2 GByte over the course of 5 days while a
ks8851 Ethernet chip on the same SPI bus handles 6 GByte of traffic.

Unfortunately the hi3110 datasheet is mum on the trigger type. The pin
description on page 3 only specifies the polarity (active high):
http://www.holtic.com/documents/371-hi-3110_v-rev-kpdf.do

Cc: Mathias Duckeck <m.duckeck@kunbus.de>
Cc: Akshay Bhat <akshay.bhat@timesys.com>
Cc: Casey Fitzpatrick <casey.fitzpatrick@timesys.com>
Signed-off-by: Lukas Wunner <lukas@wunner.de>
Cc: linux-stable <stable@vger.kernel.org>
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

---
Documentation/devicetree/bindings/net/can/holt_hi311x.txt | 2 +-
drivers/net/can/spi/hi311x.c | 2 +-
2 files changed, 2 insertions(+), 2 deletions(-)

--- a/Documentation/devicetree/bindings/net/can/holt_hi311x.txt
+++ b/Documentation/devicetree/bindings/net/can/holt_hi311x.txt
@@ -17,7 +17,7 @@ Example:
reg = <1>;
clocks = <&clk32m>;
interrupt-parent = <&gpio4>;
- interrupts = <13 IRQ_TYPE_EDGE_RISING>;
+ interrupts = <13 IRQ_TYPE_LEVEL_HIGH>;
vdd-supply = <&reg5v0>;
xceiver-supply = <&reg5v0>;
};
--- a/drivers/net/can/spi/hi311x.c
+++ b/drivers/net/can/spi/hi311x.c
@@ -760,7 +760,7 @@ static int hi3110_open(struct net_device
{
struct hi3110_priv *priv = netdev_priv(net);
struct spi_device *spi = priv->spi;
- unsigned long flags = IRQF_ONESHOT | IRQF_TRIGGER_RISING;
+ unsigned long flags = IRQF_ONESHOT | IRQF_TRIGGER_HIGH;
int ret;

ret = open_candev(net);

\
 
 \ /
  Last update: 2018-11-29 15:36    [W:0.302 / U:0.576 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site