lkml.org 
[lkml]   [2018]   [Nov]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] dmaengine: ti: omap-dma: Configure LCH_TYPE for OMAP1
From
Date


On 20/11/2018 23.04, Aaro Koskinen wrote:
> Hi,
>
> On Tue, Nov 20, 2018 at 09:28:37AM +0200, Peter Ujfalusi wrote:
>> On 19/11/2018 20.46, Aaro Koskinen wrote:
>>> On Mon, Nov 19, 2018 at 12:40:40PM +0200, Peter Ujfalusi wrote:
>>>> When the channel is configured for slave operation the LCH_TYPE needs to be
>>>> set to LCh-P. For memcpy channels the LCH_TYPE must be set to LCh-2D.
>>>>
>>>> Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
>>>
>>> I don't have the documentation, but based on what omap_udc driver (still
>>> using the legacy OMAP DMA API) does this seems to be correct.
>>
>> They are hard to fine, true. From the omap1710 TRM:
>>
>> Logical channel types (LCh types) supported are:
>> - LCh-2D for nonsynchronized transfers (memory transfers, 1D and 2D)
>> - LCh-P for synchronized transfers (mostly peripheral transfers)
>> - LCh-PD similar to LCh-P but runs on a dedicated physical channel
>> - LCh-G for graphical transfers/operations
>> - LCh-D for display transfers
>
> (I found a public document "OMAP5912 Multimedia Processor Direct
> Memory Access (DMA) Support Reference Guide", documenting these; easy
> to confuse with "OMAP5910 Dual-Core Processor System DMA Controller
> Reference Guide".)
>
>> Looking at other part it looks like hat LCH-2D channel mode can happily
>> service a peripheral. LCH-P supports the same features as LCH-2D, but it
>> lacks support for Single/Double-indexed addressing mode on the
>> peripheral port side.
>>
>> So, this patch might not be needed at all. Can you test the omap_udc
>> with s/OMAP_DMA_LCH_P/OMAP_DMA_LCH_2D
>>
>> If USB works, then we can just drop this patch.
>
> Unfortunately omap_udc does not seem to work at all anymore with DMA on
> my 770 setup. :-(
>
> I had switched to PIO mode in 2015 since the WARNs about legacy DMA
> API were too annoying and flooding the console. And now that I tried
> using DMA again with g_ether, it doesn't work anymore. The device get's
> recognized on host side, but no traffic goes through. Switching back to
> PIO makes it to work again.

After some tinkering I got omap_udc working with DMA (not DMAengine,
yet) on 770 - using nfsroot. Configuring the channels to OMAP_DMA_LCH_2D
works as expected.

This patch can be dropped.

- Péter

Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki

\
 
 \ /
  Last update: 2018-11-22 09:31    [W:0.118 / U:0.176 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site