lkml.org 
[lkml]   [2018]   [Oct]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 1/6] dt-bindings: phy: am654-mmc-phy: Document new phy bindings
From
Date
Hi Andrew,

On Friday 05 October 2018 09:28 PM, Andrew F. Davis wrote:
> On 10/04/2018 06:14 AM, Faiz Abbas wrote:
>> Add information to document bindings for the MMC PHY
>> on TI's AM654 devices.
>>
>> Signed-off-by: Faiz Abbas <faiz_abbas@ti.com>
>> Signed-off-by: Sekhar Nori <nsekhar@ti.com>
>> ---
>> .../devicetree/bindings/phy/am654-mmc-phy.txt | 42 +++++++++++++++++++
>> 1 file changed, 42 insertions(+)
>> create mode 100644 Documentation/devicetree/bindings/phy/am654-mmc-phy.txt
>>
>> diff --git a/Documentation/devicetree/bindings/phy/am654-mmc-phy.txt b/Documentation/devicetree/bindings/phy/am654-mmc-phy.txt
>> new file mode 100644
>> index 000000000000..766921612758
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/phy/am654-mmc-phy.txt
>
>
> Name ti,am654-mmc-phy.txt might be more consistent name.

Ok.

>
>
>> @@ -0,0 +1,42 @@
>> +TI AM654 MMC PHY
>> +-------------------
>> +
>> +Required properties:
>> + - compatible: ti,am654-emmc-phy
>> + - #phy-cells: must be 0
>> + - reg: PHY registers address offset and size
>> + - clocks: must be phandle of the clock provider which is the host
>> + controller
>> + - clock-names: must be "mmcclk"
>> + - ti,otap-del-sel: Output Tap Delay select.
>> + - ti,trm-icp: DLL trim select.
>> + - ti,driver-strength-ohm: driver strength in ohms.
>> + Valid values are 33, 40, 50, 66, and 100 ohms.
>> +
>> +Example:
>> + mmc_phy1: mmc_phy@10100 {
>> + compatible = "ti,am654-mmc-phy";
>> + reg = <0x10100 0x34>;
>> + clocks = <&sdhci1>;
>> + clock-names = "mmcclk";
>> + #phy-cells = <0>;
>> + ti,otap-del-sel = <0x2>;
>> + ti,trm-icp = <0x8>;
>> + status = "disabled";
>
>
> No need for disabled in the example case.

Ok.

> Also not sure the host
> controller example below needs to be here, there are already examples
> for that binding in mmc/arasan,sdhci.txt.
>

I had added it because it is a clock source in clocks=<&sdhci1> so it
should have #clock-cells and clock-output-names. I suppose I can just
reference it here.

Thanks,
Faiz

\
 
 \ /
  Last update: 2018-10-09 08:32    [W:0.057 / U:1.344 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site