lkml.org 
[lkml]   [2018]   [Oct]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v4 04/11] media: imx: Fix field negotiation
From
Date
On Thu, 2018-10-04 at 11:53 -0700, Steve Longerbeam wrote:
> IDMAC interlaced scan, a.k.a. interweave, should be enabled in the
> IDMAC output channels only if the IDMAC output pad field type is
> 'seq-bt' or 'seq-tb', and field type at the capture interface is
> 'interlaced*'.
>
> V4L2_FIELD_HAS_BOTH() macro should not be used on the input to determine
> enabling interlaced/interweave scan. That macro includes the 'interlaced'
> field types, and in those cases the data is already interweaved with
> top/bottom field lines.
>
> The CSI will capture whole frames when the source specifies alternate
> field mode. So the CSI also enables interweave for alternate input
> field type and the field type at capture interface is interlaced.
>
> Fix the logic for setting field type in try_fmt in CSI entity.
> The behavior should be:
>
> - No restrictions on field type at sink pad.
>
> - At the output pads, allow sequential fields in TB order, if the sink pad
> field type is sequential or alternate. Otherwise passthrough the field
> type from sink to source pad.
>
> Move this logic to new function csi_try_field().
>
> These changes result in the following allowed field transformations
> from CSI sink -> source pads (all other field types at sink are passed
> through to source):
>
> seq-tb -> seq-tb
> seq-bt -> seq-tb
> alternate -> seq-tb
>
> In a future patch, the CSI sink -> source will allow:
>
> seq-tb -> seq-bt
> seq-bt -> seq-bt
> alternate -> seq-bt
>
> This will require supporting interweave with top/bottom line swapping.
> Until then seq-bt is not allowed at the CSI source pad because there is
> no way to swap top/bottom lines when interweaving to INTERLACED_BT --
> note that despite the name, INTERLACED_BT is top-bottom order in memory.
> The BT in this case refers to field dominance: the bottom lines are
> older in time than the top lines.
>
> The capture interface device allows selecting IDMAC interweave by
> choosing INTERLACED_TB if the CSI/PRPENCVF source pad is seq-tb and
> INTERLACED_BT if the source pad is seq-bt (for future support of seq-bt).
>
> Signed-off-by: Steve Longerbeam <slongerbeam@gmail.com>

Reviewed-by: Philipp Zabel <p.zabel@pengutronix.de>

regards
Philipp

\
 
 \ /
  Last update: 2018-10-05 12:17    [W:0.031 / U:0.116 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site