lkml.org 
[lkml]   [2018]   [Oct]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 10/11] media: imx: Allow interweave with top/bottom lines swapped
Date
Allow sequential->interlaced interweaving but with top/bottom
lines swapped to the output buffer.

This can be accomplished by adding one line length to IDMAC output
channel address, with a negative line length for the interlace offset.

This is to allow the seq-bt -> interlaced-bt transformation, where
bottom lines are still dominant (older in time) but with top lines
first in the interweaved output buffer.

With this support, the CSI can now allow seq-bt at its source pads,
e.g. the following transformations are allowed in CSI from sink to
source:

seq-tb -> seq-bt
seq-bt -> seq-bt
alternate -> seq-bt

Suggested-by: Philipp Zabel <p.zabel@pengutronix.de>
Signed-off-by: Steve Longerbeam <slongerbeam@gmail.com>
---
drivers/staging/media/imx/imx-ic-prpencvf.c | 17 +++++++-
drivers/staging/media/imx/imx-media-csi.c | 46 +++++++++++++++++----
2 files changed, 53 insertions(+), 10 deletions(-)

diff --git a/drivers/staging/media/imx/imx-ic-prpencvf.c b/drivers/staging/media/imx/imx-ic-prpencvf.c
index cf76b0432371..1499b0c62d74 100644
--- a/drivers/staging/media/imx/imx-ic-prpencvf.c
+++ b/drivers/staging/media/imx/imx-ic-prpencvf.c
@@ -106,6 +106,8 @@ struct prp_priv {
u32 frame_sequence; /* frame sequence counter */
bool last_eof; /* waiting for last EOF at stream off */
bool nfb4eof; /* NFB4EOF encountered during streaming */
+ u32 interweave_offset; /* interweave line offset to swap
+ top/bottom lines */
struct completion last_eof_comp;
};

@@ -235,6 +237,9 @@ static void prp_vb2_buf_done(struct prp_priv *priv, struct ipuv3_channel *ch)
if (ipu_idmac_buffer_is_ready(ch, priv->ipu_buf_num))
ipu_idmac_clear_buffer(ch, priv->ipu_buf_num);

+ if (ch == priv->out_ch)
+ phys += priv->interweave_offset;
+
ipu_cpmem_set_buffer(ch, priv->ipu_buf_num, phys);
}

@@ -388,6 +393,13 @@ static int prp_setup_channel(struct prp_priv *priv,
(image.pix.width * outcc->bpp) >> 3;
}

+ priv->interweave_offset = 0;
+
+ if (interweave && image.pix.field == V4L2_FIELD_INTERLACED_BT) {
+ image.rect.top = 1;
+ priv->interweave_offset = image.pix.bytesperline;
+ }
+
image.phys0 = addr0;
image.phys1 = addr1;

@@ -425,7 +437,10 @@ static int prp_setup_channel(struct prp_priv *priv,
ipu_cpmem_set_rotation(channel, rot_mode);

if (interweave)
- ipu_cpmem_interlaced_scan(channel, image.pix.bytesperline,
+ ipu_cpmem_interlaced_scan(channel,
+ priv->interweave_offset ?
+ -image.pix.bytesperline :
+ image.pix.bytesperline,
image.pix.pixelformat);

ret = ipu_ic_task_idma_init(priv->ic, channel,
diff --git a/drivers/staging/media/imx/imx-media-csi.c b/drivers/staging/media/imx/imx-media-csi.c
index 679295da5dde..592f7d6edec1 100644
--- a/drivers/staging/media/imx/imx-media-csi.c
+++ b/drivers/staging/media/imx/imx-media-csi.c
@@ -114,6 +114,8 @@ struct csi_priv {
u32 frame_sequence; /* frame sequence counter */
bool last_eof; /* waiting for last EOF at stream off */
bool nfb4eof; /* NFB4EOF encountered during streaming */
+ u32 interweave_offset; /* interweave line offset to swap
+ top/bottom lines */
struct completion last_eof_comp;
};

@@ -286,7 +288,8 @@ static void csi_vb2_buf_done(struct csi_priv *priv)
if (ipu_idmac_buffer_is_ready(priv->idmac_ch, priv->ipu_buf_num))
ipu_idmac_clear_buffer(priv->idmac_ch, priv->ipu_buf_num);

- ipu_cpmem_set_buffer(priv->idmac_ch, priv->ipu_buf_num, phys);
+ ipu_cpmem_set_buffer(priv->idmac_ch, priv->ipu_buf_num,
+ phys + priv->interweave_offset);
}

static irqreturn_t csi_idmac_eof_interrupt(int irq, void *dev_id)
@@ -396,10 +399,10 @@ static void csi_idmac_unsetup_vb2_buf(struct csi_priv *priv,
static int csi_idmac_setup_channel(struct csi_priv *priv)
{
struct imx_media_video_dev *vdev = priv->vdev;
+ bool passthrough, interweave, interweave_swap;
const struct imx_media_pixfmt *incc;
struct v4l2_mbus_framefmt *infmt;
struct v4l2_mbus_framefmt *outfmt;
- bool passthrough, interweave;
struct ipu_image image;
u32 passthrough_bits;
u32 passthrough_cycles;
@@ -433,6 +436,8 @@ static int csi_idmac_setup_channel(struct csi_priv *priv)
*/
interweave = V4L2_FIELD_IS_INTERLACED(image.pix.field) &&
V4L2_FIELD_IS_SEQUENTIAL(outfmt->field);
+ interweave_swap = interweave &&
+ image.pix.field == V4L2_FIELD_INTERLACED_BT;

switch (image.pix.pixelformat) {
case V4L2_PIX_FMT_SBGGR8:
@@ -486,15 +491,25 @@ static int csi_idmac_setup_channel(struct csi_priv *priv)
}

if (passthrough) {
+ priv->interweave_offset = interweave_swap ?
+ image.pix.bytesperline : 0;
ipu_cpmem_set_resolution(priv->idmac_ch,
image.rect.width * passthrough_cycles,
image.rect.height);
ipu_cpmem_set_stride(priv->idmac_ch, image.pix.bytesperline);
- ipu_cpmem_set_buffer(priv->idmac_ch, 0, image.phys0);
- ipu_cpmem_set_buffer(priv->idmac_ch, 1, image.phys1);
+ ipu_cpmem_set_buffer(priv->idmac_ch, 0,
+ image.phys0 + priv->interweave_offset);
+ ipu_cpmem_set_buffer(priv->idmac_ch, 1,
+ image.phys1 + priv->interweave_offset);
ipu_cpmem_set_format_passthrough(priv->idmac_ch,
passthrough_bits);
} else {
+ priv->interweave_offset = 0;
+ if (interweave_swap) {
+ image.rect.top = 1;
+ priv->interweave_offset = image.pix.bytesperline;
+ }
+
ret = ipu_cpmem_set_image(priv->idmac_ch, &image);
if (ret)
goto unsetup_vb2;
@@ -526,6 +541,8 @@ static int csi_idmac_setup_channel(struct csi_priv *priv)

if (interweave)
ipu_cpmem_interlaced_scan(priv->idmac_ch,
+ priv->interweave_offset ?
+ -image.pix.bytesperline :
image.pix.bytesperline,
image.pix.pixelformat);

@@ -1334,16 +1351,27 @@ static void csi_try_field(struct csi_priv *priv,
switch (infmt->field) {
case V4L2_FIELD_SEQ_TB:
case V4L2_FIELD_SEQ_BT:
+ /*
+ * If the user requests sequential at the source pad,
+ * allow it (along with possibly inverting field order).
+ * Otherwise passthrough the field type.
+ */
+ if (!V4L2_FIELD_IS_SEQUENTIAL(sdformat->format.field))
+ sdformat->format.field = infmt->field;
+ break;
case V4L2_FIELD_ALTERNATE:
/*
- * If the sink is sequential or alternating fields,
- * allow only SEQ_TB at the source.
- *
* This driver does not support alternate field mode, and
* the CSI captures a whole frame, so the CSI never presents
- * alternate mode at its source pads.
+ * alternate mode at its source pads. If user has not
+ * already requested sequential, translate ALTERNATE at
+ * sink pad to SEQ_TB or SEQ_BT at the source pad depending
+ * on input height (assume NTSC BT order if 480 total active
+ * frame lines, otherwise PAL TB order).
*/
- sdformat->format.field = V4L2_FIELD_SEQ_TB;
+ if (!V4L2_FIELD_IS_SEQUENTIAL(sdformat->format.field))
+ sdformat->format.field = (infmt->height == 480 / 2) ?
+ V4L2_FIELD_SEQ_BT : V4L2_FIELD_SEQ_TB;
break;
default:
/* Passthrough for all other input field types */
--
2.17.1
\
 
 \ /
  Last update: 2018-10-04 20:55    [W:0.086 / U:0.416 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site