lkml.org 
[lkml]   [2018]   [Oct]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] mmc: sdhci-pci: Try "cd" for card-detect lookup before using NULL
On Mon, Oct 29, 2018 at 10:22:02AM -0700, Rajat Jain wrote:
> On Mon, Oct 29, 2018 at 8:23 AM Andy Shevchenko
> <andy.shevchenko@gmail.com> wrote:
> > On Wed, Oct 24, 2018 at 9:03 PM Dmitry Torokhov <dtor@google.com> wrote:
> > > On Wed, Oct 24, 2018 at 3:02 AM Andy Shevchenko
> > > <andy.shevchenko@gmail.com> wrote:
> > > > On Mon, Oct 22, 2018 at 04:34:55PM -0700, Rajat Jain wrote:
> > > > > On Fri, Oct 19, 2018 at 2:13 AM Andy Shevchenko
> > > > > <andy.shevchenko@gmail.com> wrote:

> > > > > Also, the driver may not
> > > > > really know?
> > > >
> > > > I think in such case the bug in HW design and / or driver.
> > >
> > > Why? You can have a shared or dedicated interrupt and the driver does
> > > not really need to know if it can poll the status.
> >
> > Yes, that's my point either we get 1:1 mapping between slot and GPIOs
> > or have a possibility to read back from some register(s) the actual
> > status of all of them, otherwise it's a bad design.
>
> No, AFAIU, the driver only should only be able to read the status of
> *the* interrupt that was fired? (as opposite to the ability to read
> *all of them* when an interrupt fires).

I can't be sure in the details of this (sdhci) driver, I'm not a maintainer of
that one. So, my above conclusions are purely generic.

> > > > > 2) I'm not really sure what should I set "active_low" to? Isn't this
> > > > > something that should be specified by platform / ACPI too, and driver
> > > > > should just be able to say say choose whatever the ACPI says?
> > > > >
> > > > > struct acpi_gpio_params {
> > > > > unsigned int crs_entry_index;
> > > > > unsigned int line_index;
> > > > > bool active_low;
> > > > > };


> > > > ACPI specification misses this property, that's why we have it in the
> > > > structure. In your case it should be provided by _DSD and thus be consistent
> > > > with the hardcoded values.
> > >
> > > Again, you think as if the driver was platform specific; it is not. I
> > > have 1000s of systems with different ACPI tables. Let's say half of
> > > them use one polarity, and half another. Which polarity do you propose
> > > to use?
> >
> > Use one table for one half and another for the rest.
>
> But how does driver determine which table to use for which platform?
> (Currently the driver is platform independent).

Based on vendor and device IDs in any form of it.

--
With Best Regards,
Andy Shevchenko


\
 
 \ /
  Last update: 2018-10-29 18:47    [W:0.064 / U:12.080 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site