lkml.org 
[lkml]   [2018]   [Oct]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 08/17] thermal: qcom: tsens: enable+check sensor after its setup is finished
On Wed, Oct 17, 2018 at 9:24 PM Bartlomiej Zolnierkiewicz
<b.zolnierkie@samsung.com> wrote:
>
> Enable+check sensor after setting tmdev->sensor[i].tzd and calling
> chipset specific enable operation.
>
> Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
> ---
> drivers/thermal/qcom/tsens.c | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/thermal/qcom/tsens.c b/drivers/thermal/qcom/tsens.c
> index dbd2556..01bff96 100644
> --- a/drivers/thermal/qcom/tsens.c
> +++ b/drivers/thermal/qcom/tsens.c
> @@ -105,13 +105,13 @@ static int tsens_register(struct tsens_device *tmdev)
> if (IS_ERR(tzd))
> continue;
>
> - thermal_zone_set_mode(tzd, THERMAL_DEVICE_ENABLED);
> - thermal_zone_device_check(tzd);
> -

I don't quite understand why you're making this move explicitly in a
separate patch for each of the drivers? You added it here in patch 4
in the first place, why not add it in the correct place there itself?


> tmdev->sensor[i].tzd = tzd;
>
> if (tmdev->ops->enable)
> tmdev->ops->enable(tmdev, i);
> +
> + thermal_zone_set_mode(tzd, THERMAL_DEVICE_ENABLED);
> + thermal_zone_device_check(tzd);
>
> }
> return 0;
> }
> --
> 1.9.1
>

\
 
 \ /
  Last update: 2018-10-26 14:12    [W:0.081 / U:2.196 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site