lkml.org 
[lkml]   [2018]   [Oct]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2] zynq-fpga: Only route PR via PCAP when required
Date
The Xilinx Zynq FPGA driver takes ownership of the PR interface, making
it impossible to use the ICAP interface for partial reconfiguration.

This patch changes the driver to only activate PR over PCAP while the
device is actively being accessed by the driver for programming.

This allows both PCAP and ICAP interfaces to be used for PR.

Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
Reviewed-by: Moritz Fischer <mdf@kernel.org>
---
v2: Move the register setting in between the clock enable/disable

drivers/fpga/zynq-fpga.c | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/drivers/fpga/zynq-fpga.c b/drivers/fpga/zynq-fpga.c
index 3110e00..ff3a427 100644
--- a/drivers/fpga/zynq-fpga.c
+++ b/drivers/fpga/zynq-fpga.c
@@ -501,6 +501,10 @@ static int zynq_fpga_ops_write_complete(struct fpga_manager *mgr,
if (err)
return err;

+ /* Release 'PR' control back to the ICAP */
+ zynq_fpga_write(priv, CTRL_OFFSET,
+ zynq_fpga_read(priv, CTRL_OFFSET) & ~CTRL_PCAP_PR_MASK);
+
err = zynq_fpga_poll_timeout(priv, INT_STS_OFFSET, intr_status,
intr_status & IXR_PCFG_DONE_MASK,
INIT_POLL_DELAY,
--
1.9.1
\
 
 \ /
  Last update: 2018-10-24 09:57    [W:0.074 / U:13.276 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site