lkml.org 
[lkml]   [2018]   [Oct]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 16/17] thermal: zx2967: enable+check sensor after its setup is finished
Date
Enable+check sensor after checking sensor coefficients.

Cc: Jun Nie <jun.nie@linaro.org>
Cc: Baoyou Xie <baoyou.xie@linaro.org>
Cc: Shawn Guo <shawnguo@kernel.org>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
---
drivers/thermal/zx2967_thermal.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/thermal/zx2967_thermal.c b/drivers/thermal/zx2967_thermal.c
index 3c08e1d..4e30b1f 100644
--- a/drivers/thermal/zx2967_thermal.c
+++ b/drivers/thermal/zx2967_thermal.c
@@ -168,9 +168,6 @@ static int zx2967_thermal_probe(struct platform_device *pdev)
goto disable_clk_all;
}

- thermal_zone_set_mode(priv->tzd, THERMAL_DEVICE_ENABLED);
- thermal_zone_device_check(priv->tzd);
-
if (priv->tzd->tzp->slope == 0) {
thermal_zone_of_sensor_unregister(&pdev->dev, priv->tzd);
dev_err(&pdev->dev, "coefficients of sensor is invalid\n");
@@ -178,6 +175,9 @@ static int zx2967_thermal_probe(struct platform_device *pdev)
goto disable_clk_all;
}

+ thermal_zone_set_mode(priv->tzd, THERMAL_DEVICE_ENABLED);
+ thermal_zone_device_check(priv->tzd);
+
priv->dev = &pdev->dev;
platform_set_drvdata(pdev, priv);

--
1.9.1
\
 
 \ /
  Last update: 2018-10-17 17:55    [W:0.159 / U:6.828 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site