lkml.org 
[lkml]   [2018]   [Oct]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 15/17] thermal: uniphier: enable+check sensor after its setup is finished
Date
Enable sensor after checking trip points (unipher_tm_enable_sensor()
enables IRQ so we need to toggle sensor before calling it) and check
sensor after doing chipset specific enable sensor operation.

Cc: Masahiro Yamada <yamada.masahiro@socionext.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
---
drivers/thermal/uniphier_thermal.c | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/thermal/uniphier_thermal.c b/drivers/thermal/uniphier_thermal.c
index ed3a920..9ccc1fc 100644
--- a/drivers/thermal/uniphier_thermal.c
+++ b/drivers/thermal/uniphier_thermal.c
@@ -307,9 +307,6 @@ static int uniphier_tm_probe(struct platform_device *pdev)
return PTR_ERR(tdev->tz_dev);
}

- thermal_zone_set_mode(tdev->tz_dev, THERMAL_DEVICE_ENABLED);
- thermal_zone_device_check(tdev->tz_dev);
-
/* get trip points */
trips = of_thermal_get_trip_points(tdev->tz_dev);
ntrips = of_thermal_get_ntrips(tdev->tz_dev);
@@ -332,8 +329,12 @@ static int uniphier_tm_probe(struct platform_device *pdev)
return -EINVAL;
}

+ thermal_zone_set_mode(tdev->tz_dev, THERMAL_DEVICE_ENABLED);
+
uniphier_tm_enable_sensor(tdev);

+ thermal_zone_device_check(tdev->tz_dev);
+
return 0;
}

--
1.9.1
\
 
 \ /
  Last update: 2018-10-17 17:55    [W:0.174 / U:2.428 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site