lkml.org 
[lkml]   [2018]   [Oct]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH net-next] net: ethernet: ti: cpsw: use for mcast entries only host port
From
Date


On 10/12/2018 11:06 AM, Ivan Khoronzhuk wrote:
> In dual-emac mode the cpsw driver sends directed packets, that means
> that packets go to the directed port, but an ALE lookup is performed
> to determine untagged egress only. It means that on tx side no need
> to add port bit for ALE mcast entry mask, and basically ALE entry
> for port identification is needed only on rx side.
>
> So, add only host port in dual_emac mode as used directed
> transmission, and no need in one more port. For single port boards
> and switch mode all ports used, as usual, so no changes for them.
> Also it simplifies farther changes.
>
> In other words, mcast entries for dual-emac should behave exactly
> like unicast. It also can help avoid leaking packets between ports
> with same vlan on h/w level if ports could became members of same vid.
>
> So now, for instance, if mcast address 33:33:00:00:00:01 is added then
> entries in ALE table:
>
> vid = 1, addr = 33:33:00:00:00:01, port_mask = 0x1
> vid = 2, addr = 33:33:00:00:00:01, port_mask = 0x1
>
> Instead of:
> vid = 1, addr = 33:33:00:00:00:01, port_mask = 0x3
> vid = 2, addr = 33:33:00:00:00:01, port_mask = 0x5
>
> With the same considerations, set only host port for unregistered
> mcast for dual-emac mode in case of IFF_ALLMULTI is set, exactly like
> it's done in cpsw_ale_set_allmulti().
>
> Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk@linaro.org>
> ---
>
> Based on net-next/master



Thank you.
Reviewed-by: Grygorii Strashko <grygorii.strashko@ti.com>

--
regards,
-grygorii

\
 
 \ /
  Last update: 2018-10-13 02:43    [W:3.755 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site