Messages in this thread Patch in this message | | | Date | Tue, 9 Jan 2018 16:17:35 +0100 | From | Antoine Tenart <> | Subject | Re: [PATCH net-next v3 4/4] net: mvpp2: 2500baseX support |
| |
Hi Russell,
On Tue, Jan 09, 2018 at 02:44:48PM +0000, Russell King - ARM Linux wrote: > On Tue, Jan 09, 2018 at 09:59:45AM +0100, Antoine Tenart wrote: > > This patch adds the 2500Base-X PHY mode support in the Marvell PPv2 > > driver. 2500Base-X is quite close to 1000Base-X and SGMII modes and uses > > nearly the same code path. > > Sorry, also...
Comments always welcomed :)
> > @@ -4668,6 +4692,10 @@ static void mvpp2_port_mii_gmac_configure_mode(struct mvpp2_port *port) > > */ > > val |= MVPP2_GMAC_CONFIG_GMII_SPEED | > > MVPP2_GMAC_CONFIG_FULL_DUPLEX; > > + else if (port->phy_interface == PHY_INTERFACE_MODE_2500BASEX) > > + val |= MVPP2_GMAC_CONFIG_GMII_SPEED | > > + MVPP2_GMAC_CONFIG_MII_SPEED | > > + MVPP2_GMAC_CONFIG_FULL_DUPLEX; > > I think you'll find you don't need to set MII_SPEED here, since > MII_SPEED selects between 10 and 100, GMII_SPEED always takes > precidence selecting 1000, and 2500 is done by the comphy > increasing the clocks by 2.5x.
I just had a look at the datasheet, and as you say it seems GMII_SPEED takes over MII_SPEED. I'll see if there is a corner case here or if selecting MII_SPEED doesn't make sense, and update accordingly.
Thanks! Antoine
-- Antoine Ténart, Free Electrons Embedded Linux and Kernel engineering http://free-electrons.com
| |