Messages in this thread |  | | Date | Tue, 23 Jan 2018 09:44:57 +0100 | | From | Greg KH <> | | Subject | Re: [PATCH arm/aspeed/ast2500 v1] eSPI: add Aspeed AST2500 eSPI driver to boot a host with PCH runs on eSPI |
| |
On Tue, Jan 16, 2018 at 07:52:32PM +0800, Haiyue Wang wrote: > When PCH works under eSPI mode, the PMC (Power Management Controller) in > PCH is waiting for SUS_ACK from BMC after it alerts SUS_WARN. It is in > dead loop if no SUS_ACK assert. This is the basic requirement for the BMC > works as eSPI slave. > > Also for the host power on / off actions, from BMC side, the following VW > (Virtual Wire) messages are done in firmware: > 1. SLAVE_BOOT_LOAD_DONE / SLAVE_BOOT_LOAD_STATUS > 2. SUS_ACK > 3. OOB_RESET_ACK > 4. HOST_RESET_ACK > > Signed-off-by: Haiyue Wang <haiyue.wang@linux.intel.com> > --- > .../devicetree/bindings/misc/aspeed-espi-slave.txt | 20 ++ > Documentation/misc-devices/espi-slave.rst | 114 +++++++++
DT files need to be split out into a separate patch so that the DT maintainers can properly review them.
> --- a/drivers/misc/Kconfig > +++ b/drivers/misc/Kconfig > @@ -471,6 +471,17 @@ config VEXPRESS_SYSCFG > ARM Ltd. Versatile Express uses specialised platform configuration > bus. System Configuration interface is one of the possible means > of generating transactions on this bus. > +config ASPEED_ESPI_SLAVE
You need a blank line above this one please.
> + depends on ARCH_ASPEED || COMPILE_TEST > + select REGMAP_MMIO
Select or depend?
> + tristate "Aspeed ast2500 eSPI slave device" > + ---help--- > + This allows host to access Baseboard Management Controller (BMC) over the > + Enhanced Serial Peripheral Interface (eSPI) bus, which replaces the Low Pin > + Count (LPC) bus. > + > + Its interface supports peripheral, virtual wire, out-of-band, and flash > + sharing channels.
What is the module name?
> > config ASPEED_LPC_CTRL > depends on (ARCH_ASPEED || COMPILE_TEST) && REGMAP && MFD_SYSCON > diff --git a/drivers/misc/Makefile b/drivers/misc/Makefile > index 5ca5f64..a1081f4 100644 > --- a/drivers/misc/Makefile > +++ b/drivers/misc/Makefile > @@ -52,6 +52,7 @@ obj-$(CONFIG_GENWQE) += genwqe/ > obj-$(CONFIG_ECHO) += echo/ > obj-$(CONFIG_VEXPRESS_SYSCFG) += vexpress-syscfg.o > obj-$(CONFIG_CXL_BASE) += cxl/ > +obj-$(CONFIG_ASPEED_ESPI_SLAVE) += aspeed-espi-slave.o
Why no tab?
thanks,
greg k-h
|  |