lkml.org 
[lkml]   [2018]   [Jan]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH V1 3/4] usb: serial: f81534: add output pin control
On Tue, Jan 02, 2018 at 11:24:26AM +0800, Ji-Ze Hong (Peter Hong) wrote:
> Hi Johan,
>
> >> In this code, I'm only read/write 3 registers of 0x2ae8, 0x2a90, 0x2a80,
> >> but some register will read/write more than once. Should I change the
> >> code from port_probe() to attach() and re-write it as:
> >> 1: read the 3 register
> >> 2: change them will 12 pin desire value
> >> 3: write it back
> >> Is it ok?
> >
> > Do you expect these pins to ever be changed after probe? If not, then
> > perhaps it can be moved to attach(), but otherwise I guess they should
> > be set at port_probe(). By using shadow registers, you should be able to
> > reduce the number of device accesses, but perhaps it's not worth the
> > complexity.
> >
> > Do you have a rough idea about how long these register updates take? I
> > was just worried that these changes will add up to really long probe
> > times.
> >
>
> I had measured the time of the loop in f81534_set_port_output_pin() via
> getnstimeofday() with 685.410 ~ 3681.682us per port, but normally with
> 600~800us per port. So I prefer remain the current method of
> f81534_set_port_output_pin(). Is it ok?

That should be fine. Thanks for verifying.

Johan

\
 
 \ /
  Last update: 2018-01-02 10:28    [W:0.044 / U:0.052 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site