lkml.org 
[lkml]   [2018]   [Jan]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 0/2] PM / core: genpd fix and pm_runtime_force_suspend|resume() rework
On Mon, Jan 15, 2018 at 3:26 PM, Ulf Hansson <ulf.hansson@linaro.org> wrote:
> On 15 January 2018 at 14:22, Geert Uytterhoeven <geert@linux-m68k.org> wrote:

[cut]

>>
>> I did miss a small difference in topology: in pm/linux-next, H3 has DMA
>> enabled for SCIF2, while M3 hasn't (yet).
>> With DMA enabled on M3, it fails in the same way.
>>
>> As genpd_resume_noirq() no longer calls pm_runtime_force_resume(),
>> rcar_dmac_runtime_resume() is no longer called, and the DMAC's registers
>> are no longer reinitialized after system resume, breaking the serial port.
>
> In drivers/dma/sh/rcar-dmac.c, I would try to replace the below line:
> SET_SYSTEM_SLEEP_PM_OPS(rcar_dmac_sleep_suspend, rcar_dmac_sleep_resume)
>
> with:
> SET_SYSTEM_SLEEP_PM_OPS(pm_runtime_force_suspend, pm_runtime_force_resume)

Yes, that probably is the least intrusive thing that can be done to
address the issue.

> in case that may be too early to suspend the dma device (which is
> rather common for dma devices) then try;
>
> SET_LATE_SYSTEM_SLEEP_PM_OPS(pm_runtime_force_suspend, pm_runtime_force_resume)

Good suggestion, and I would go straight for it anyway.

Geert, can you try if this works, please?

Thanks,
Rafael

\
 
 \ /
  Last update: 2018-01-15 17:18    [W:0.038 / U:0.020 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site