lkml.org 
[lkml]   [2018]   [Jan]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCHv2 1/5] net: dsa: Support internal phy on 'cpu' port
Date
This adds support for enabling the internal PHY for a 'cpu' port.
It has been tested on GE B850v3, B650v3 and B450v3, which have a
built-in MV88E6240 switch connected to a PCIe based network card.
Without this patch the link does not come up and no traffic can be
routed through the switch.

The PHY interface, that is being used on the above test systems is
part of the MV88E6240 and since mv88e6xxx driver resets the chip
during probe, it is definitely disabled without this patch.

Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.co.uk>
---
net/dsa/port.c | 23 +++++++++++++++++++----
1 file changed, 19 insertions(+), 4 deletions(-)

diff --git a/net/dsa/port.c b/net/dsa/port.c
index bb4be2679904..33ea0d73350d 100644
--- a/net/dsa/port.c
+++ b/net/dsa/port.c
@@ -282,6 +282,10 @@ int dsa_port_fixed_link_register_of(struct dsa_port *dp)
int mode;
int err;

+ mode = of_get_phy_mode(dn);
+ if (mode < 0)
+ mode = PHY_INTERFACE_MODE_NA;
+
if (of_phy_is_fixed_link(dn)) {
err = of_phy_register_fixed_link(dn);
if (err) {
@@ -292,10 +296,6 @@ int dsa_port_fixed_link_register_of(struct dsa_port *dp)
}

phydev = of_phy_find_device(dn);
-
- mode = of_get_phy_mode(dn);
- if (mode < 0)
- mode = PHY_INTERFACE_MODE_NA;
phydev->interface = mode;

genphy_config_init(phydev);
@@ -305,6 +305,21 @@ int dsa_port_fixed_link_register_of(struct dsa_port *dp)
ds->ops->adjust_link(ds, port, phydev);

put_device(&phydev->mdio.dev);
+ } else if (mode == PHY_INTERFACE_MODE_INTERNAL) {
+ phydev = mdiobus_get_phy(ds->slave_mii_bus, port);
+ if (!phydev) {
+ dev_err(ds->dev, "port %d has no internal phy!", port);
+ return -ENODEV;
+ }
+
+ genphy_config_init(phydev);
+ genphy_resume(phydev);
+ genphy_read_status(phydev);
+
+ if (ds->ops->adjust_link)
+ ds->ops->adjust_link(ds, port, phydev);
+
+ dev_dbg(ds->dev, "enabled port's phy: %s", phydev_name(phydev));
}

return 0;
--
2.15.1
\
 
 \ /
  Last update: 2018-01-15 13:17    [W:0.084 / U:0.180 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site