lkml.org 
[lkml]   [2018]   [Jan]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 15/17] ASoC: fsl_ssi: Add bool synchronous to mark synchronous mode
Date
Using symmetric_rates in the cpu_dai_drv is a bit implicit,
so this patch adds a bool synchronous instead.

Signed-off-by: Nicolin Chen <nicoleotsuka@gmail.com>
Tested-by: Caleb Crome <caleb@crome.org>
---
Changelog
v3
* Removed all cpu_dai_drv changes in PATCH-15

sound/soc/fsl/fsl_ssi.c | 13 ++++++++-----
1 file changed, 8 insertions(+), 5 deletions(-)

diff --git a/sound/soc/fsl/fsl_ssi.c b/sound/soc/fsl/fsl_ssi.c
index aa4c006..dfeca43 100644
--- a/sound/soc/fsl/fsl_ssi.c
+++ b/sound/soc/fsl/fsl_ssi.c
@@ -217,6 +217,7 @@ struct fsl_ssi_soc_data {
* @dai_fmt: DAI configuration this device is currently used with
* @streams: Mask of current active streams: BIT(TX) and BIT(RX)
* @i2s_net: I2S and Network mode configurations of SCR register
+ * @synchronous: Use synchronous mode - both of TX and RX use STCK and SFCK
* @use_dma: DMA is used or FIQ with stream filter
* @use_dual_fifo: DMA with support for dual FIFO mode
* @has_ipg_clk_name: If "ipg" is in the clock name list of device tree
@@ -262,6 +263,7 @@ struct fsl_ssi {
unsigned int dai_fmt;
u8 streams;
u8 i2s_net;
+ bool synchronous;
bool use_dma;
bool use_dual_fifo;
bool has_ipg_clk_name;
@@ -673,7 +675,6 @@ static int fsl_ssi_set_bclk(struct snd_pcm_substream *substream,
bool tx2, tx = substream->stream == SNDRV_PCM_STREAM_PLAYBACK;
struct fsl_ssi *ssi = snd_soc_dai_get_drvdata(dai);
struct regmap *regs = ssi->regs;
- int synchronous = ssi->cpu_dai_drv.symmetric_rates, ret;
u32 pm = 999, div2, psr, stccr, mask, afreq, factor, i;
unsigned long clkrate, baudrate, tmprate;
unsigned int slots = params_channels(hw_params);
@@ -681,6 +682,7 @@ static int fsl_ssi_set_bclk(struct snd_pcm_substream *substream,
u64 sub, savesub = 100000;
unsigned int freq;
bool baudclk_is_used;
+ int ret;

/* Override slots and slot_width if being specifically set... */
if (ssi->slots)
@@ -759,7 +761,7 @@ static int fsl_ssi_set_bclk(struct snd_pcm_substream *substream,
mask = SSI_SxCCR_PM_MASK | SSI_SxCCR_DIV2 | SSI_SxCCR_PSR;

/* STCCR is used for RX in synchronous mode */
- tx2 = tx || synchronous;
+ tx2 = tx || ssi->synchronous;
regmap_update_bits(regs, REG_SSI_SxCCR(tx2), mask, stccr);

if (!baudclk_is_used) {
@@ -807,7 +809,7 @@ static int fsl_ssi_hw_params(struct snd_pcm_substream *substream,
* that should set separate configurations for STCCR and SRCCR
* despite running in the synchronous mode.
*/
- if (enabled && ssi->cpu_dai_drv.symmetric_rates)
+ if (enabled && ssi->synchronous)
return 0;

if (fsl_ssi_is_i2s_master(ssi)) {
@@ -839,7 +841,7 @@ static int fsl_ssi_hw_params(struct snd_pcm_substream *substream,
}

/* In synchronous mode, the SSI uses STCCR for capture */
- tx2 = tx || ssi->cpu_dai_drv.symmetric_rates;
+ tx2 = tx || ssi->synchronous;
regmap_update_bits(regs, REG_SSI_SxCCR(tx2), SSI_SxCCR_WL_MASK, wl);

return 0;
@@ -968,7 +970,7 @@ static int _fsl_ssi_set_dai_fmt(struct fsl_ssi *ssi, unsigned int fmt)
srcr = strcr;

/* Set SYN mode and clear RXDIR bit when using SYN or AC97 mode */
- if (ssi->cpu_dai_drv.symmetric_rates || fsl_ssi_is_ac97(ssi)) {
+ if (ssi->synchronous || fsl_ssi_is_ac97(ssi)) {
srcr &= ~SSI_SRCR_RXDIR;
scr |= SSI_SCR_SYN;
}
@@ -1450,6 +1452,7 @@ static int fsl_ssi_probe(struct platform_device *pdev)
if (!fsl_ssi_is_ac97(ssi)) {
ssi->cpu_dai_drv.symmetric_rates = 1;
ssi->cpu_dai_drv.symmetric_samplebits = 1;
+ ssi->synchronous = true;
}

ssi->cpu_dai_drv.symmetric_channels = 1;
--
2.7.4
\
 
 \ /
  Last update: 2018-01-16 00:17    [W:0.096 / U:8.960 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site