[lkml]   [2017]   [Aug]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v8 0/2] Add spi-nor flash device pm support
Changes since v7 

- Fix comment style

- Fix condition check to set_4byte() when nor->addr_width == 4 in spi_nor_init()
- Bring back quad_enable logic to spi_nor_setup() and remove it from spi_nor_scan()
- Remove duplicate comment section in spi_nor_scan()
- Leave dev_info() string as before in spi_nor_scan()

The V8 changes below implements power management support using the mtd
handlers for resume in the spi-nor driver. spi-nor mtd pm resume() calls
newly implemented spi_nor_init() function that sets up the spi-nor flash
to its pre-suspend/power-on probed state. This is needed S2/S3 PM
on platfroms that turn off power to the spi-nor flash on pm suspend.

Kamal Dasu (2):
mtd: spi-nor: add spi_nor_init() function
mtd: spi-nor: Add spi-nor mtd resume handler

drivers/mtd/spi-nor/spi-nor.c | 68 +++++++++++++++++++++++++++++++------------
include/linux/mtd/spi-nor.h | 10 +++++++
2 files changed, 60 insertions(+), 18 deletions(-)


 \ /
  Last update: 2017-08-22 22:47    [W:0.079 / U:13.828 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site