lkml.org 
[lkml]   [2017]   [Aug]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 3/3] ACPI / PMIC: Add opregion driver for Intel Dollar Cove TI PMIC
From
Date
On Tue, 2017-08-22 at 14:37 +0300, Andy Shevchenko wrote:
> On Tue, 2017-08-22 at 13:01 +0200, Takashi Iwai wrote:
> > On Tue, 22 Aug 2017 12:25:12 +0200,
> > Takashi Iwai wrote:

> > > > Does it mean the register is big endian?
> > >
> > > Good point, I need to check the original code and the values.
> >
> > It's really big-endian, the order is hi:lo.
> >
> > But, admittedly, the temperature code hasn't been tested, and it's
> > possibly missing something.  So I'm fine to drop that part in the
> > first version, too.
>
> I don't know if regmap allows you to define registers with different
> sizes for same chip, perhaps it would make sense to start register
> from
> hi part (and not doing non-intuitive "- 1", or maybe "+ 1" instead)
> and
> mark it in comment that is BE16.

I have just checked datasheet, so, there are 4 pairs of BE16 registers. 

VBAT (Hi:Lo) 0x54
DIETEMP 0x56
BPTHERM 0x58
GPADC 0x5a

So, I would create a separate address mapping for them, dropping out
that _LOW suffix and put a comment that they are BE16 since ADC has 10-
bit resolution.

Or even do a separate ADC driver under drivers/iio/adc for PMIC(s).

--
Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Intel Finland Oy

\
 
 \ /
  Last update: 2017-08-22 14:13    [W:0.083 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site