lkml.org 
[lkml]   [2017]   [Jul]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] thermal: intel_pch_thermal: Fix enable check on Broadwell-DE
Date
Using the TSDSS flag to determine whether the thermal sensor is
enabled is problematic. Broadwell-DE (Xeon D-1500) does not support
dynamic shutdown and the TSDSS flag always reads 0 (contrary to the
current datasheet). Even on hardware supporting dynamic shutdown, the
driver does nothing to configure it, and the dynamic shutdown state
should not prevent the driver from loading. The ETS flag itself
indicates whether the thermal sensor is enabled, so use it instead of
the TSDSS flag on all hardware platforms.

Signed-off-by: Ed Swierk <eswierk@skyportsystems.com>
---
drivers/thermal/intel_pch_thermal.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/thermal/intel_pch_thermal.c b/drivers/thermal/intel_pch_thermal.c
index 2b49e8d..9889c90 100644
--- a/drivers/thermal/intel_pch_thermal.c
+++ b/drivers/thermal/intel_pch_thermal.c
@@ -125,7 +125,7 @@ static int pch_wpt_init(struct pch_thermal_device *ptd, int *nr_trips)
*nr_trips = 0;

/* Check if BIOS has already enabled thermal sensor */
- if (WPT_TSS_TSDSS & readb(ptd->hw_base + WPT_TSS)) {
+ if (WPT_TSEL_ETS & readb(ptd->hw_base + WPT_TSEL)) {
ptd->bios_enabled = true;
goto read_trips;
}
@@ -141,7 +141,7 @@ static int pch_wpt_init(struct pch_thermal_device *ptd, int *nr_trips)
}

writeb(tsel|WPT_TSEL_ETS, ptd->hw_base + WPT_TSEL);
- if (!(WPT_TSS_TSDSS & readb(ptd->hw_base + WPT_TSS))) {
+ if (!(WPT_TSEL_ETS & readb(ptd->hw_base + WPT_TSEL))) {
dev_err(&ptd->pdev->dev, "Sensor can't be enabled\n");
return -ENODEV;
}
--
1.9.1
\
 
 \ /
  Last update: 2017-07-20 23:16    [W:0.029 / U:0.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site