lkml.org 
[lkml]   [2017]   [Jul]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] net: ethernet: fsl: add phy reset after clk enable option
On Thu, Jul 06, 2017 at 03:05:30PM +0200, Richard Leitner wrote:
> Some PHYs (for example the LAN8710) doesn't allow turning the clocks off
> and on again without reset (according to their datasheet). Exactly this
> behaviour was introduced for power saving reasons by commit e8fcfcd5684a
> ("net: fec: optimize the clock management to save power")
> Therefore add a devictree option to perform a PHY reset and
> configuration after every clock enable.
>
> For a better understanding here's a outline of the time response of the
> clock and reset lines before and after this patch:
>
> v--fec_probe() v--fec_enet_open()
> v v
> w/o patch eCLK: ___||||||||____________________|||||||||||||||||
> w/o patch nRST: ----__------------------------------------------
> w/o patch CONF: _______XX_______________________________________
>
> w/ patch eCLK: ___||||||||____________________|||||||||||||||||
> w/ patch nRST: ----__--------------------------__--------------
> w/ patch CONF: _______XX__________________________XX___________
> ^ ^
> ^--fec_probe() ^--fec_enet_open()
>
> In our case this problem does occur at about every 10th to 50th POR of
> an LAN8710 connected to an i.MX6 SoC. The typical symptom of this
> problem is a "swinging" ethernet link. Similar issues were experienced
> by users of the NXP forum:
> https://community.nxp.com/thread/389902
> https://community.nxp.com/message/309354
> With this patch applied the issue didn't occur for at least a few
> hundred PORs of our board.
>
> Fixes: e8fcfcd5684a ("net: fec: optimize the clock management to sa...")
> Signed-off-by: Richard Leitner <richard.leitner@skidata.com>
> ---
> Documentation/devicetree/bindings/net/fsl-fec.txt | 3 +++
> drivers/net/ethernet/freescale/fec.h | 1 +
> drivers/net/ethernet/freescale/fec_main.c | 16 ++++++++++++++++
> 3 files changed, 20 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/net/fsl-fec.txt b/Documentation/devicetree/bindings/net/fsl-fec.txt
> index 6f55bdd..1766579 100644
> --- a/Documentation/devicetree/bindings/net/fsl-fec.txt
> +++ b/Documentation/devicetree/bindings/net/fsl-fec.txt
> @@ -23,6 +23,9 @@ Optional properties:
> - phy-handle : phandle to the PHY device connected to this device.
> - fixed-link : Assume a fixed link. See fixed-link.txt in the same directory.
> Use instead of phy-handle.
> +- phy-reset-after-clk-enable : If present then a phy reset and configuration
> + will be performed everytime after the clocks are enabled. This is required
> + for some PHYs to work properly.

Maybe this is not needed based on the discussion, but just to make
sure. Since this is a property of the phy, it should be implied from the
phy's compatible string.

Rob

\
 
 \ /
  Last update: 2017-07-10 15:27    [W:0.040 / U:0.020 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site