lkml.org 
[lkml]   [2017]   [Jun]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v8 12/34] ARM: dts: imx6-sabreauto: add reset-gpios property for max7310_b
Date
The reset pin to the port expander chip (MAX7310) is controlled by a gpio,
so define a reset-gpios property to control it. There are three MAX7310's
on the SabreAuto CPU card (max7310_[abc]), but all use the same pin for
their reset. Since all can't acquire the same pin, assign it to max7310_b,
that chip is needed by more functions (usb and adv7180).

Signed-off-by: Steve Longerbeam <steve_longerbeam@mentor.com>
---
arch/arm/boot/dts/imx6qdl-sabreauto.dtsi | 9 +++++++++
1 file changed, 9 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
index c8e35c4..21dea5f 100644
--- a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
@@ -136,6 +136,9 @@
reg = <0x32>;
gpio-controller;
#gpio-cells = <2>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_max7310>;
+ reset-gpios = <&gpio1 15 GPIO_ACTIVE_LOW>;
};

max7310_c: gpio@34 {
@@ -441,6 +444,12 @@
>;
};

+ pinctrl_max7310: max7310grp {
+ fsl,pins = <
+ MX6QDL_PAD_SD2_DAT0__GPIO1_IO15 0x1b0b0
+ >;
+ };
+
pinctrl_pwm3: pwm1grp {
fsl,pins = <
MX6QDL_PAD_SD4_DAT1__PWM3_OUT 0x1b0b1
--
2.7.4
\
 
 \ /
  Last update: 2017-06-12 01:09    [W:0.736 / U:0.164 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site