lkml.org 
[lkml]   [2017]   [Jun]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v5 00/23] mtd: nand: denali: Denali NAND IP patch bomb
Date
This patch series intends to solve various problems.

[1] The driver just retrieves the OOB area as-is
whereas the controller uses syndrome page layout.
[2] Many NAND chip specific parameters are hard-coded in the driver.
[3] ONFi devices are not working
[4] It can not read Bad Block Marker

Outstanding changes are:
- Fix raw/oob callbacks for syndrome page layout
- Implement setup_data_interface() callback
- Fix/implement more commands for ONFi devices
- Allow to skip the driver internal bounce buffer
- Support PIO in case DMA is not supported
- Switch from ->cmdfunc over to ->cmd_ctrl

18 patches were merged at v2.
11 patches were merged at v3.
2 patches were merged at 4.
Here is the rest of the series.

v1: https://lkml.org/lkml/2016/11/26/144
v2: https://lkml.org/lkml/2017/3/22/804
v3: https://lkml.org/lkml/2017/3/30/90


Masahiro Yamada (23):
mtd: nand: add generic helpers to check, match, maximize ECC settings
mtd: nand: add a shorthand to generate nand_ecc_caps structure
mtd: nand: denali: avoid hard-coding ECC step, strength, bytes
mtd: nand: denali: remove Toshiba and Hynix specific fixup code
mtd: nand: denali_dt: add compatible strings for UniPhier SoC variants
mtd: nand: denali: set NAND_ECC_CUSTOM_PAGE_ACCESS
mtd: nand: denali: do not propagate NAND_STATUS_FAIL to waitfunc()
mtd: nand: denali: remove unneeded find_valid_banks()
mtd: nand: denali: handle timing parameters by setup_data_interface()
mtd: nand: denali: rework interrupt handling
mtd: nand: denali: fix NAND_CMD_STATUS handling
mtd: nand: denali: fix NAND_CMD_PARAM handling
mtd: nand: denali: switch over to cmd_ctrl instead of cmdfunc
mtd: nand: denali: fix bank reset function to detect the number of
chips
mtd: nand: denali: use interrupt instead of polling for bank reset
mtd: nand: denali: propagate page to helpers via function argument
mtd: nand: denali: merge struct nand_buf into struct denali_nand_info
mtd: nand: denali: use flag instead of register macro for direction
mtd: nand: denali: fix raw and oob accessors for syndrome page layout
mtd: nand: denali: support hardware-assisted erased page detection
mtd: nand: denali: skip driver internal bounce buffer when possible
mtd: nand: denali: use non-managed kmalloc() for DMA buffer
mtd: nand: denali: enable bad block table scan

.../devicetree/bindings/mtd/denali-nand.txt | 13 +
drivers/mtd/nand/denali.c | 1686 +++++++++-----------
drivers/mtd/nand/denali.h | 60 +-
drivers/mtd/nand/denali_dt.c | 33 +-
drivers/mtd/nand/denali_pci.c | 10 +-
drivers/mtd/nand/nand_base.c | 220 +++
include/linux/mtd/nand.h | 47 +
7 files changed, 1103 insertions(+), 966 deletions(-)

--
2.7.4

\
 
 \ /
  Last update: 2017-06-12 01:04    [W:0.289 / U:1.588 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site