lkml.org 
[lkml]   [2017]   [Jun]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RESEND PATCH v4] clk: stm32h7: Add stm32h743 clock driver
On 06/30, Gabriel FERNANDEZ wrote:
>
>
> On 06/30/2017 02:20 AM, Stephen Boyd wrote:
> > On 06/29, Gabriel FERNANDEZ wrote:
> >>
> >> On 06/28/2017 05:59 PM, Stephen Boyd wrote:
> >>> On 06/27, Gabriel FERNANDEZ wrote:
> >>>> On 06/22/2017 12:07 AM, Stephen Boyd wrote:
> >>>>> readl_poll_timeout?
> >>>>>
> >>>> if i use readl_poll_timeout (wich use 'ktime_get()') it can be
> >>>> operational only after the selection of clocksource ? (device_initcall).
> >>>> And then if a driver turn on a clock before, it could blocked the linux
> >>>> console ?
> >>>>
> >>> Ok. I wonder if we could add some sort of starting check to
> >>> readl_poll_timeout() that tests system_state for booting vs.
> >>> scheduling? That should be sufficient to handle this case?
> >>>
> >> Oops i think i understood my problem...
> >> i used readl_poll_timeout in atomic context.
> >> I have to move my code in the .prepare ops.
> >>
> >> If you are ok with that i will send a v5
> >>
> > There's readl_poll_timeout_atomic() for those modes.
> >
> yes it's exactly the test i made (use 'readl_poll_timeout()_atomic' in
> .enable ops) but i'm blocked.
>
> if i do the same in .prepare ops with 'readl_poll_timeout()' it's ok.

I'm still confused. readl_poll_timeout_atomic() uses ktime_get(),
and so does readl_poll_timeout(), so how does moving to the
prepare op fix the problem? What's the actual problem?

--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project

\
 
 \ /
  Last update: 2017-06-30 23:15    [W:0.065 / U:1.444 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site