Messages in this thread Patch in this message | | | From | Vignesh R <> | Subject | [linux-next][PATCH] usb: dwc3: core: Call dwc3_core_get_phy() before initializing phys | Date | Thu, 29 Jun 2017 10:55:14 +0530 |
| |
commit f54edb539c116 ("usb: dwc3: core: initialize ULPI before trying to get the PHY") moved call to dwc3_core_get_phy() from dwc3_probe() to dwc3_core_init() after dwc3_core_soft_reset(). But dwc3_core_soft_reset() calls phy_init(), therefore dwc3_core_get_phy() needs to be called before dwc3_core_soft_reset().
Fix this by moving call to dwc3_core_get_phy() before dwc3_core_soft_reset().
This fixes the following abort seen on DRA7xx platforms [ 24.769118] usb usb2: SerialNumber: xhci-hcd.1.auto [ 24.781144] hub 2-0:1.0: USB hub found [ 24.787836] hub 2-0:1.0: 1 port detected [ 24.809939] Unhandled fault: imprecise external abort (0x1406) at 0x00000000
Reported-by: Carlos Hernandez <ceh@ti.com> Signed-off-by: Vignesh R <vigneshr@ti.com> --- drivers/usb/dwc3/core.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/usb/dwc3/core.c b/drivers/usb/dwc3/core.c index 326b302fc440..03474d3575ab 100644 --- a/drivers/usb/dwc3/core.c +++ b/drivers/usb/dwc3/core.c @@ -766,15 +766,15 @@ static int dwc3_core_init(struct dwc3 *dwc) dwc->maximum_speed = USB_SPEED_HIGH; } - ret = dwc3_core_soft_reset(dwc); + ret = dwc3_core_get_phy(dwc); if (ret) goto err0; - ret = dwc3_phy_setup(dwc); + ret = dwc3_core_soft_reset(dwc); if (ret) goto err0; - ret = dwc3_core_get_phy(dwc); + ret = dwc3_phy_setup(dwc); if (ret) goto err0; -- 2.13.0
| |