lkml.org 
[lkml]   [2017]   [Jun]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 14/20] dt-bindings: serial: document option wake-up interrupt for STM32 USART
Date
From: Bich Hemon <bich.hemon@st.com>

Introduce new compatibles for "st,stm32h7-usart" and "st,stm32h7-uart".
This new compatible allow to use optional wake-up interrupt.

Signed-off-by: Fabrice Gasnier <fabrice.gasnier@st.com>
---
.../devicetree/bindings/serial/st,stm32-usart.txt | 20 ++++++++++++++++----
1 file changed, 16 insertions(+), 4 deletions(-)

diff --git a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt
index a229b14..3b42138 100644
--- a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt
+++ b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt
@@ -2,11 +2,14 @@

Required properties:
- compatible: Can be either "st,stm32-usart", "st,stm32-uart",
-"st,stm32f7-usart" or "st,stm32f7-uart" depending on whether
-the device supports synchronous mode and is compatible with
-stm32(f4) or stm32f7.
+"st,stm32f7-usart", "st,stm32f7-uart", "st,stm32h7-usart" or
+st,stm32h7-uart depending on whether the device supports synchronous
+mode and is compatible with stm32(f4), stm32f7 or stm32h7.
- reg: The address and length of the peripheral registers space
-- interrupts: The interrupt line of the USART instance
+- interrupts or interrupts-extended: Must contain first, the interrupt
+ line specifier for the USART instance. An optional wake-up interrupt
+ specifier can be added. Then, -extended variant may be needed to specify
+ interrupts parent controllers.
- clocks: The input clock of the USART instance

Optional properties:
@@ -53,3 +56,12 @@ usart1: serial@40011000 {
<&dma2 7 4 0x414 0x0>;
dma-names = "rx", "tx";
};
+
+uart4: serial@40010000 {
+ compatible = "st,stm32h7-uart";
+ reg = <0x40010000 0x400>;
+ interrupts-extended = <&intc GIC_SPI 52 IRQ_TYPE_NONE>,
+ <&aiec 30 1>;
+ clocks = <&rcc UART4_K>;
+ status = "disabled";
+};
--
1.9.1
\
 
 \ /
  Last update: 2017-06-26 14:54    [W:0.230 / U:0.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site