lkml.org 
[lkml]   [2017]   [Jun]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v5 04/11] arm64: dts: Initial DTS files for Broadcom Stingray SOC
From
Date


On 05/26/2017 02:24 AM, Anup Patel wrote:
> The Broadcom Stingray SoC is a new member in Broadcom iProc
> SoC family.
>
> This patch adds initial DTS files for Broadcom Stingray SoC
> and two of its reference boards (bcm958742k and bcm958742t).
>
> We have lot of reference boards and large number of devices
> in Broadcom Stingray SoC so eventually we will have quite
> a few DTS files for Stingray. To tackle, we have added a
> separate directory for Stingray DTS files.

So I was going to apply this, but...


> + scr {
> + compatible = "simple-bus";
> + #address-cells = <1>;
> + #size-cells = <1>;
> + ranges = <0x0 0x0 0x61000000 0x05000000>;

So you corrected the ranges property here...

> +
> + gic: interrupt-controller@63c00000 {

but you kept the original unit address here, which does not match the
reg property, could you fix that through your entire submission?

> + compatible = "arm,gic-v3";
> + #interrupt-cells = <3>;
> + #address-cells = <1>;
> + #size-cells = <1>;
> + ranges;
> + interrupt-controller;
> + reg = <0x02c00000 0x010000>, /* GICD */
> + <0x02e00000 0x600000>; /* GICR */

> + hsls {
> + compatible = "simple-bus";
> + #address-cells = <1>;
> + #size-cells = <1>;
> + ranges = <0x0 0x0 0x68900000 0x17700000>;

Same here.

> +
> + uart0: uart@68a00000 {
> + device_type = "serial";
> + compatible = "snps,dw-apb-uart";
> + reg = <0x00100000 0x1000>;

and here and all other sub nodes
--
Florian

\
 
 \ /
  Last update: 2017-06-05 00:07    [W:0.072 / U:0.316 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site