Messages in this thread | | | From | Andy Shevchenko <> | Date | Wed, 14 Jun 2017 15:20:13 +0300 | Subject | Re: [PATCH v11 5/6] i2c: designware: add SLAVE mode functions |
| |
On Wed, Jun 14, 2017 at 1:43 PM, Luis Oliveira <Luis.Oliveira@synopsys.com> wrote: > - Changes in Kconfig to enable I2C_DESIGNWARE_SLAVE support > - Slave functions added to core library file > - Slave abort sources added to common source file > - New driver: i2c-designware-slave added > - Changes in the Makefile to compile the I2C_DESIGNWARE_SLAVE module > when supported by the architecture. > > All the SLAVE flow is added but it is not enabled via platform > driver.
> + //~ if (stat & DW_IC_INTR_TX_OVER) > + //~ dw_readl(dev, DW_IC_CLR_TX_OVER);
If you are going to ignore reviewers' comments you will delay your work to be applied.
Certainly you are about to miss v4.13.
-- With Best Regards, Andy Shevchenko
| |