lkml.org 
[lkml]   [2017]   [May]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH v2] net: fec: add post PHY reset delay DT property
Date
From: Rob Herring <robh@kernel.org> Sent: Thursday, June 01, 2017 12:44 AM
>On Tue, May 23, 2017 at 11:48:08AM +0200, Quentin Schulz wrote:
>> Some PHY require to wait for a bit after the reset GPIO has been
>> toggled. This adds support for the DT property `phy-reset-post-delay`
>> which gives the delay in milliseconds to wait after reset.
>>
>> If the DT property is not given, no delay is observed. Post reset
>> delay greater than 1000ms are invalid.
>>
>> Signed-off-by: Quentin Schulz <quentin.schulz@free-electrons.com>
>> ---
>>
>> v2:
>> - return -EINVAL when phy-reset-post-delay is greater than 1000ms
>> instead of defaulting to 1ms,
>> - remove `default to 1ms` when phy-reset-post-delay > 1000Ms from DT
>> binding doc and commit log,
>> - move phy-reset-post-delay property reading before
>> devm_gpio_request_one(),
>>
>> Documentation/devicetree/bindings/net/fsl-fec.txt | 4 ++++
>> drivers/net/ethernet/freescale/fec_main.c | 16 +++++++++++++++-
>> 2 files changed, 19 insertions(+), 1 deletion(-)
>>
>> diff --git a/Documentation/devicetree/bindings/net/fsl-fec.txt
>> b/Documentation/devicetree/bindings/net/fsl-fec.txt
>> index a1e3693cca16..6f55bdd52f8a 100644
>> --- a/Documentation/devicetree/bindings/net/fsl-fec.txt
>> +++ b/Documentation/devicetree/bindings/net/fsl-fec.txt
>> @@ -15,6 +15,10 @@ Optional properties:
>> - phy-reset-active-high : If present then the reset sequence using the GPIO
>> specified in the "phy-reset-gpios" property is reversed (H=reset state,
>> L=operation state).
>> +- phy-reset-post-delay : Post reset delay in milliseconds. If present
>> +then
>
>This needs unit suffix minimally. It should also have a vendor prefix or be
>made generic.
>
>But really, this is a property of the phy and should be in the phy node as
>should phy-reset-gpios, phy-reset-active-high, phy-supply, etc.
>
Yes, it is better to make it general.
Last year, Uwe Kleine-König's patch "Commit da47b4572056 ("phy: add support for a reset-gpio specification")" did this, but it was reverted by commit 948350140ef0 (Revert "phy: add support for a reset-gpio specification"). And in all phy device driver, only at803x.c add the gpio reset in currently.

\
 
 \ /
  Last update: 2017-06-01 03:40    [W:0.087 / U:0.240 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site