lkml.org 
[lkml]   [2017]   [May]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v8 net-next 16/17] dt-bindings: qca7000: append UART interface to binding
Date
This merges the serdev binding for the QCA7000 UART driver (Ethernet over
UART) into the existing document.

Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
---
.../devicetree/bindings/net/qca,qca7000.txt | 32 ++++++++++++++++++++++
1 file changed, 32 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/qca,qca7000.txt b/Documentation/devicetree/bindings/net/qca,qca7000.txt
index a37f656..6d9efb2 100644
--- a/Documentation/devicetree/bindings/net/qca,qca7000.txt
+++ b/Documentation/devicetree/bindings/net/qca,qca7000.txt
@@ -54,3 +54,35 @@ ssp2: spi@80014000 {
local-mac-address = [ A0 B0 C0 D0 E0 F0 ];
};
};
+
+(b) Ethernet over UART
+
+In order to use the QCA7000 as UART slave it must be defined as a child of a
+UART master in the device tree. It is possible to preconfigure the UART
+settings of the QCA7000 firmware, but it's not possible to change them during
+runtime.
+
+Required properties:
+- compatible : Should be "qca,qca7000"
+
+Optional properties:
+- local-mac-address : see ./ethernet.txt
+- current-speed : current baud rate of QCA7000 which defaults to 115200
+ if absent, see also ../serial/slave-device.txt
+
+UART Example:
+
+/* Freescale i.MX28 UART */
+auart0: serial@8006a000 {
+ compatible = "fsl,imx28-auart", "fsl,imx23-auart";
+ reg = <0x8006a000 0x2000>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&auart0_2pins_a>;
+ status = "okay";
+
+ qca7000: ethernet {
+ compatible = "qca,qca7000";
+ local-mac-address = [ A0 B0 C0 D0 E0 F0 ];
+ current-speed = <38400>;
+ };
+};
--
2.1.4
\
 
 \ /
  Last update: 2017-05-29 14:01    [W:0.266 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site