lkml.org 
[lkml]   [2017]   [May]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 6/6] serial: exar: Add support for IOT2040 device
On Thu, May 18, 2017 at 4:59 PM, Jan Kiszka <jan.kiszka@siemens.com> wrote:

> This implements the setup of RS232 and the switch-over to RS485 or RS422
> for the Siemens IOT2040. That uses an EXAR XR17V352 with external logic
> to switch between the different modes. The external logic is controlled
> via MPIO pins of the EXAR controller.
>
> Only pin 10 can be exported as GPIO on the IOT2040. It is connected to
> an LED.
>
> As the XR17V352 used on the IOT2040 is not equipped with an external
> EEPROM, it cannot present itself as IOT2040-variant via subvendor/
> subdevice IDs. Thus, we have to check via DMI for the target platform.
>
> Co-developed with Sascha Weisenberger.
>
> Signed-off-by: Sascha Weisenberger <sascha.weisenberger@siemens.com>
> Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>

Will this thing collide with your fixups so that Greg should take all
exar patches or can this be applied to the serial tree orthogonally?

Yours,
Linus Walleij

\
 
 \ /
  Last update: 2017-05-22 17:48    [W:0.325 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site