lkml.org 
[lkml]   [2017]   [May]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 39/53] mtd: adjust kernel-docs to avoid Sphinx/kerneldoc warnings
On Tue, 16 May 2017 09:16:31 -0300
Mauro Carvalho Chehab <mchehab@s-opensource.com> wrote:

> ./drivers/mtd/nand/nand_bbt.c:1: warning: no structured comments found
> ./include/linux/mtd/nand.h:785: ERROR: Unexpected indentation.
> ./drivers/mtd/nand/nand_base.c:449: WARNING: Definition list ends without a blank line; unexpected unindent.
> ./drivers/mtd/nand/nand_base.c:1161: ERROR: Unexpected indentation.
> ./drivers/mtd/nand/nand_base.c:1162: WARNING: Block quote ends without a blank line; unexpected unindent.
>
> Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>

Acked-by: Boris Brezillon <boris.brezillon@free-electrons.com>

> ---
> Documentation/driver-api/mtdnand.rst | 3 ---
> drivers/mtd/nand/nand_base.c | 7 +++++--
> include/linux/mtd/nand.h | 2 +-
> 3 files changed, 6 insertions(+), 6 deletions(-)
>
> diff --git a/Documentation/driver-api/mtdnand.rst b/Documentation/driver-api/mtdnand.rst
> index 7c19795ebb4a..e9afa586d15e 100644
> --- a/Documentation/driver-api/mtdnand.rst
> +++ b/Documentation/driver-api/mtdnand.rst
> @@ -970,9 +970,6 @@ hints" for an explanation.
> .. kernel-doc:: drivers/mtd/nand/nand_base.c
> :export:
>
> -.. kernel-doc:: drivers/mtd/nand/nand_bbt.c
> - :export:
> -
> .. kernel-doc:: drivers/mtd/nand/nand_ecc.c
> :export:
>
> diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c
> index b0524f8accb6..c8988c01e0d7 100644
> --- a/drivers/mtd/nand/nand_base.c
> +++ b/drivers/mtd/nand/nand_base.c
> @@ -442,10 +442,12 @@ static int nand_default_block_markbad(struct mtd_info *mtd, loff_t ofs)
> * specify how to write bad block markers to OOB (chip->block_markbad).
> *
> * We try operations in the following order:
> + *
> * (1) erase the affected block, to allow OOB marker to be written cleanly
> * (2) write bad block marker to OOB area of affected block (unless flag
> * NAND_BBT_NO_OOB_BBM is present)
> * (3) update the BBT
> + *
> * Note that we retain the first error encountered in (2) or (3), finish the
> * procedures, and dump the error in the end.
> */
> @@ -1155,9 +1157,10 @@ int nand_reset(struct nand_chip *chip, int chipnr)
> * @mtd: mtd info
> * @ofs: offset to start unlock from
> * @len: length to unlock
> - * @invert: when = 0, unlock the range of blocks within the lower and
> + * @invert:
> + * - when = 0, unlock the range of blocks within the lower and
> * upper boundary address
> - * when = 1, unlock the range of blocks outside the boundaries
> + * - when = 1, unlock the range of blocks outside the boundaries
> * of the lower and upper boundary address
> *
> * Returs unlock status.
> diff --git a/include/linux/mtd/nand.h b/include/linux/mtd/nand.h
> index 9591e0fbe5bd..3d5b20379ba3 100644
> --- a/include/linux/mtd/nand.h
> +++ b/include/linux/mtd/nand.h
> @@ -779,7 +779,7 @@ nand_get_sdr_timings(const struct nand_data_interface *conf)
> * Minimum amount of bit errors per @ecc_step_ds guaranteed
> * to be correctable. If unknown, set to zero.
> * @ecc_step_ds: [INTERN] ECC step required by the @ecc_strength_ds,
> - * also from the datasheet. It is the recommended ECC step
> + * also from the datasheet. It is the recommended ECC step
> * size, if known; if unknown, set to zero.
> * @onfi_timing_mode_default: [INTERN] default ONFI timing mode. This field is
> * set to the actually used ONFI mode if the chip is

\
 
 \ /
  Last update: 2017-05-16 15:35    [W:0.396 / U:0.304 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site