lkml.org 
[lkml]   [2017]   [May]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Date
Subject[PATCH 2/2] switchtec: fix minor bug with partition id register
When a switch endpoind is configured without NTB the mmio_ntb registers
will read all zeros. However, in corner case configurations where the
partition ID is not zero and NTB is not enabled then the code will have
the wrong partition ID and this causes the driver to use the wrong
set of drivers. To fix this we simply take the partition ID from the
system info region.

Signed-off-by: Logan Gunthorpe <logang@deltatee.com>
Reported-by: Dingbao Chen <dingbao.chen@microsemi.com>
---
drivers/pci/switch/switchtec.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/pci/switch/switchtec.c b/drivers/pci/switch/switchtec.c
index abaa227a..f6a6340 100644
--- a/drivers/pci/switch/switchtec.c
+++ b/drivers/pci/switch/switchtec.c
@@ -1441,12 +1441,15 @@ static int switchtec_init_pci(struct switchtec_dev *stdev,
stdev->mmio_sys_info = stdev->mmio + SWITCHTEC_GAS_SYS_INFO_OFFSET;
stdev->mmio_flash_info = stdev->mmio + SWITCHTEC_GAS_FLASH_INFO_OFFSET;
stdev->mmio_ntb = stdev->mmio + SWITCHTEC_GAS_NTB_OFFSET;
- stdev->partition = ioread8(&stdev->mmio_ntb->partition_id);
+ stdev->partition = ioread8(&stdev->mmio_sys_info->partition_id);
stdev->partition_count = ioread8(&stdev->mmio_ntb->partition_count);
stdev->mmio_part_cfg_all = stdev->mmio + SWITCHTEC_GAS_PART_CFG_OFFSET;
stdev->mmio_part_cfg = &stdev->mmio_part_cfg_all[stdev->partition];
stdev->mmio_pff_csr = stdev->mmio + SWITCHTEC_GAS_PFF_CSR_OFFSET;

+ if (stdev->partition_count < 1)
+ stdev->partition_count = 1;
+
init_pff(stdev);

pci_set_drvdata(pdev, stdev);
--
2.1.4
\
 
 \ /
  Last update: 2017-05-15 18:46    [W:0.132 / U:0.240 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site