[lkml]   [2017]   [May]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[RESEND PATCH v5 0/3] Support for USB DRD Phy driver for NS2
Resending the patchset v5.
Commit message for dts patch is edited as suggested by Florian.

Changes in v5:
Removed references to phy_ops in the same driver by connect_work
event handler to change the phy modes.

To support dynamically changing the mode of the phy, it does
not require doing a phy reset/programming of PHY PLL. Changes
are made to the connect_work routine to just program the required
register bits to achieve this purpose.

Changes in v4:
Remove references to edev->name in debug prints.

Changes in v3:
Remove unnecessary checks for poweron as suggested in review.

Changes in v2:
1. Initialize file operations .owner field with THIS_MODULE.
2. Remove unnecessary gpio example in DT bindings documentation.
This is previously acked by Rob Herring <>

Introduction for PATCH v1:

This patch adds support for USB Dual Role Device Phy for Broadcom
Northstar2 SoC. Apart from the new phy driver, this patchset contains
changes to Kconfig, Makefile, and Device tree files.

This patchset is tested on Broadcom NS2 BCM958712K reference board.

Branch: ns2_drdphy_v5

Raviteja Garimella (3):
dt-bindings:phy:Add DT bindings documentation for NS2 USB DRD phy
phy:phy-bcm-ns2-usbdrd:Broadcom USB DRD Phy driver for Northstar2
arm64: dts: NS2: Add USB DRD PHY device tree node

.../devicetree/bindings/phy/brcm,ns2-drd-phy.txt | 30 ++
arch/arm64/boot/dts/broadcom/ns2.dtsi | 14 +
drivers/phy/Kconfig | 13 +
drivers/phy/Makefile | 1 +
drivers/phy/phy-bcm-ns2-usbdrd.c | 595 +++++++++++++++++++++
5 files changed, 653 insertions(+)
create mode 100644 Documentation/devicetree/bindings/phy/brcm,ns2-drd-phy.txt
create mode 100644 drivers/phy/phy-bcm-ns2-usbdrd.c


 \ /
  Last update: 2017-05-10 21:20    [W:0.149 / U:36.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site