Messages in this thread | | | From | Linus Walleij <> | Date | Mon, 24 Apr 2017 16:29:05 +0200 | Subject | Re: [PATCH] pinctrl: make artpec6 explicitly non-modular |
| |
On Wed, Apr 19, 2017 at 9:59 PM, Paul Gortmaker <paul.gortmaker@windriver.com> wrote:
> The Kconfig currently controlling compilation of this code is: > > drivers/pinctrl/Kconfig:config PINCTRL_ARTPEC6 > drivers/pinctrl/Kconfig: bool "Axis ARTPEC-6 pin controller driver" > > ...meaning that it currently is not being built as a module by anyone. > > Lets remove the modular code that is essentially orphaned, so that > when reading the driver there is no doubt it is builtin-only. > > Also note that MODULE_DEVICE_TABLE is a no-op for non-modular code. > > We also delete the MODULE_LICENSE tag etc. since all that information > is already contained at the top of the file in the comments. > > Cc: Jesper Nilsson <jesper.nilsson@axis.com> > Cc: Lars Persson <lars.persson@axis.com> > Cc: Niklas Cassel <niklas.cassel@axis.com> > Cc: Linus Walleij <linus.walleij@linaro.org> > Cc: linux-arm-kernel@axis.com > Cc: linux-gpio@vger.kernel.org > Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
Patch applied with Jesper's ACK.
Yours, Linus Walleij
| |