lkml.org 
[lkml]   [2017]   [Apr]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/2] regulator: tps65132: add device-tree binding
Date
Add tps65132 regulator device-tree binding documentation

Signed-off-by: Venkat Reddy Talla <vreddytalla@nvidia.com>
---
Changes for v2:
- change dts property names
- add reg dts property
---
.../bindings/regulator/tps65132-regulator.txt | 46 ++++++++++++++++++++++
1 file changed, 46 insertions(+)
create mode 100644 Documentation/devicetree/bindings/regulator/tps65132-regulator.txt

diff --git a/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt b/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
new file mode 100644
index 0000000..3a35055
--- /dev/null
+++ b/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
@@ -0,0 +1,46 @@
+TPS65132 regulators
+
+Required properties:
+- compatible: "ti,tps65132"
+- reg: I2C slave address
+
+Optional Subnode:
+Device supports two regulators OUTP and OUTN. A sub node within the
+ device node describe the properties of these regulators. The sub-node
+ names must be as follows:
+ -For regulator outp, the sub node name should be "outp".
+ -For regulator outn, the sub node name should be "outn".
+
+-enable-gpios:(active high, output) Regulators are controlled by the input pins.
+ If it is connected to GPIO through host system then provide the
+ gpio number as per gpio.txt.
+-active-discharge-gpios: (active high, output) Some configurations use delay mechanisms
+ on the enable pin, to keep the regulator enabled for some time after
+ the enable signal goes low. This GPIO is used to actively discharge
+ the delay mechanism. Requires specification of ti,active-discharge-time-us
+-ti,active-discharge-time-us: how long the active discharge gpio should be
+ asserted for during active discharge, in microseconds.
+
+Each regulator is defined using the standard binding for regulators.
+
+Example:
+
+ tps65132@3e {
+ compatible = "ti,tps65132";
+ reg = <0x3e>;
+
+ outp {
+ regulator-name = "outp";
+ regulator-boot-on;
+ regulator-always-on;
+ enable-gpios = <&gpio 23 0>;
+ };
+
+ outn {
+ regulator-name = "outn";
+ regulator-boot-on;
+ regulator-always-on;
+ regulator-active-discharge = <0>;
+ enable-gpios = <&gpio 40 0>;
+ };
+ };
--
2.1.4
\
 
 \ /
  Last update: 2017-04-12 12:15    [W:0.031 / U:8.304 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site