Messages in this thread | | | Date | Thu, 30 Mar 2017 19:56:39 +0100 | From | Russell King - ARM Linux <> | Subject | Re: [PATCH v7 00/13] mmc: Add support to Marvell Xenon SD Host Controller |
| |
On Thu, Mar 30, 2017 at 05:22:52PM +0200, Gregory CLEMENT wrote: > - Remove parse of child node mmc-card. Wait for a better solution.
So for mcbin, I have:
&ap_sdhci0 { bus-width = <8>; marvell,xenon-emmc; marvell,xenon-phy-type = "emmc 5.1 phy"; /* * Not stable in HS modes - phy needs "more calibration", so add * the "slow-mode" and disable SDR104, SDR50 and DDR50 modes. */ marvell,xenon-phy-slow-mode; no-1-8-v; non-removable; status = "okay"; vqmmc-supply = <&v_vddo_h>;
#address-cells = <1>; #size-cells = <0>; mmccard: mmccard@0 { compatible = "mmc-card"; reg = <0>; }; };
Does this mean the "mmccard" bit is no longer required - or is it required for the eMMC to be detected but is no longer supported by the driver?
Thanks.
-- RMK's Patch system: http://www.armlinux.org.uk/developer/patches/ FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up according to speedtest.net.
| |