lkml.org 
[lkml]   [2017]   [Dec]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RFC] irqchip: add support for LS1021A external interrupt lines
Date
The LS1021A allows inverting the polarity of six interrupt lines
IRQ[0:5] via the scfg_intpcr register, effectively allowing
IRQ_TYPE_LEVEL_LOW and IRQ_TYPE_EDGE_FALLING for those. We just need to
check the type, set the relevant bit in INTPCR accordingly, and fixup
the type argument before calling the GIC's irq_set_type.

In fact, the power-on-reset value of the INTPCR register is so that all
six lines have their polarity inverted. Hence any hardware connected to
those lines is unusable without this: If the line is indeed active low,
the generic GIC code will reject an irq spec with IRQ_TYPE_LEVEL_LOW,
while if the line is active high, we must obviously disable the polarity
inversion before unmasking the interrupt.

I suspect other layerscape SOCs may have something similar, but I have
neither hardware nor documentation.

Since we only need to keep a single pointer in the chip_data (the syscon
regmap), the code could be a little simpler by dropping the struct
extirq_chip_data and just store the regmap directly - but I don't know
if I do need to add a lock or something else to the chip_data, so for
this RFC I've kept the struct.

Signed-off-by: Rasmus Villemoes <rasmus.villemoes@prevas.dk>
---
Marc, Alexander, thanks a lot for your hints. This is what I came up
with, mostly just copy-pasted from the mtk-sysirq case. I've tested
that it works as expected on my board.

.../interrupt-controller/fsl,ls1021a-extirq.txt | 19 +++
drivers/irqchip/Makefile | 1 +
drivers/irqchip/irq-ls1021a.c | 157 +++++++++++++++++++++
3 files changed, 177 insertions(+)
create mode 100644 Documentation/devicetree/bindings/interrupt-controller/fsl,ls1021a-extirq.txt
create mode 100644 drivers/irqchip/irq-ls1021a.c

diff --git a/Documentation/devicetree/bindings/interrupt-controller/fsl,ls1021a-extirq.txt b/Documentation/devicetree/bindings/interrupt-controller/fsl,ls1021a-extirq.txt
new file mode 100644
index 000000000000..53b04b6e1a80
--- /dev/null
+++ b/Documentation/devicetree/bindings/interrupt-controller/fsl,ls1021a-extirq.txt
@@ -0,0 +1,19 @@
+* Freescale LS1021A external IRQs
+
+The LS1021A supports inverting the polarity of six external interrupt lines.
+
+Required properties:
+- compatible: should be "fsl,ls1021a-extirq"
+- interrupt-controller: Identifies the node as an interrupt controller
+- #interrupt-cells: Use the same format as specified by GIC in arm,gic.txt.
+- interrupt-parent: phandle of GIC.
+- syscon: phandle of Supplemental Configuration Unit (scfg).
+
+Example:
+ extirq: interrupt-controller@15701ac {
+ compatible = "fsl,ls1021a-extirq";
+ #interrupt-cells = <3>;
+ interrupt-controller;
+ interrupt-parent = <&gic>;
+ syscon = <&scfg>;
+ };
diff --git a/drivers/irqchip/Makefile b/drivers/irqchip/Makefile
index b842dfdc903f..d4576dce24b2 100644
--- a/drivers/irqchip/Makefile
+++ b/drivers/irqchip/Makefile
@@ -80,3 +80,4 @@ obj-$(CONFIG_ARCH_ASPEED) += irq-aspeed-vic.o irq-aspeed-i2c-ic.o
obj-$(CONFIG_STM32_EXTI) += irq-stm32-exti.o
obj-$(CONFIG_QCOM_IRQ_COMBINER) += qcom-irq-combiner.o
obj-$(CONFIG_IRQ_UNIPHIER_AIDET) += irq-uniphier-aidet.o
+obj-$(CONFIG_SOC_LS1021A) += irq-ls1021a.o
diff --git a/drivers/irqchip/irq-ls1021a.c b/drivers/irqchip/irq-ls1021a.c
new file mode 100644
index 000000000000..2ec4fc023549
--- /dev/null
+++ b/drivers/irqchip/irq-ls1021a.c
@@ -0,0 +1,157 @@
+#define pr_fmt(fmt) "irq-ls1021a: " fmt
+
+#include <linux/irq.h>
+#include <linux/irqchip.h>
+#include <linux/irqdomain.h>
+#include <linux/of.h>
+#include <linux/of_irq.h>
+#include <linux/of_address.h>
+#include <linux/mfd/syscon.h>
+#include <linux/regmap.h>
+#include <linux/slab.h>
+
+#define INTPCR_REG 0x01ac
+#define NIRQ 6
+
+struct extirq_chip_data {
+ struct regmap *syscon;
+};
+
+static int
+ls1021a_extirq_set_type(struct irq_data *data, unsigned int type)
+{
+ irq_hw_number_t hwirq = data->hwirq;
+ struct extirq_chip_data *chip_data = data->chip_data;
+ u32 value, mask;
+ int ret;
+
+ mask = 1U << (31 - hwirq);
+ if (type == IRQ_TYPE_LEVEL_LOW || type == IRQ_TYPE_EDGE_FALLING) {
+ if (type == IRQ_TYPE_LEVEL_LOW)
+ type = IRQ_TYPE_LEVEL_HIGH;
+ else
+ type = IRQ_TYPE_EDGE_RISING;
+ value = mask;
+ } else {
+ value = 0;
+ }
+
+ /* Don't do the INTPCR_REG update if the parent irq_set_type will EINVAL. */
+ if (type != IRQ_TYPE_LEVEL_HIGH && type != IRQ_TYPE_EDGE_RISING)
+ return -EINVAL;
+
+ /* regmap does internal locking, but do we need to provide our
+ * own across the parent irq_set_type call? */
+ regmap_update_bits(chip_data->syscon, INTPCR_REG, mask, value);
+
+ data = data->parent_data;
+ ret = data->chip->irq_set_type(data, type);
+
+ return ret;
+}
+
+static struct irq_chip extirq_chip = {
+ .name = "LS1021A_EXTIRQ",
+ .irq_mask = irq_chip_mask_parent,
+ .irq_unmask = irq_chip_unmask_parent,
+ .irq_eoi = irq_chip_eoi_parent,
+ .irq_set_type = ls1021a_extirq_set_type,
+ .irq_retrigger = irq_chip_retrigger_hierarchy,
+ .irq_set_affinity = irq_chip_set_affinity_parent,
+};
+
+static int
+ls1021a_extirq_domain_translate(struct irq_domain *d, struct irq_fwspec *fwspec,
+ unsigned long *hwirq, unsigned int *type)
+{
+ if (!is_of_node(fwspec->fwnode))
+ return -EINVAL;
+
+ if (fwspec->param_count != 3)
+ return -EINVAL;
+
+ /* No PPI should point to this domain */
+ if (fwspec->param[0] != 0)
+ return -EINVAL;
+
+ *hwirq = fwspec->param[1];
+ *type = fwspec->param[2] & IRQ_TYPE_SENSE_MASK;
+ return 0;
+}
+
+static int
+ls1021a_extirq_domain_alloc(struct irq_domain *domain, unsigned int virq,
+ unsigned int nr_irqs, void *arg)
+{
+ static const unsigned xlate[NIRQ] = {163,164,165,167,168,169};
+ int i;
+ irq_hw_number_t hwirq;
+ struct irq_fwspec *fwspec = arg;
+ struct irq_fwspec gic_fwspec;
+
+ if (fwspec->param_count != 3)
+ return -EINVAL;
+
+ if (fwspec->param[0])
+ return -EINVAL;
+
+ hwirq = fwspec->param[1];
+ for (i = 0; i < nr_irqs; i++)
+ irq_domain_set_hwirq_and_chip(domain, virq + i, hwirq + i,
+ &extirq_chip,
+ domain->host_data);
+
+ gic_fwspec.fwnode = domain->parent->fwnode;
+ gic_fwspec.param_count = 3;
+ gic_fwspec.param[0] = 0;
+ gic_fwspec.param[1] = xlate[hwirq];
+ gic_fwspec.param[2] = fwspec->param[2];
+
+ return irq_domain_alloc_irqs_parent(domain, virq, nr_irqs, &gic_fwspec);
+}
+
+static const struct irq_domain_ops extirq_domain_ops = {
+ .translate = ls1021a_extirq_domain_translate,
+ .alloc = ls1021a_extirq_domain_alloc,
+ .free = irq_domain_free_irqs_common,
+};
+
+static int __init
+ls1021a_extirq_of_init(struct device_node *node, struct device_node *parent)
+{
+
+ struct irq_domain *domain, *domain_parent;
+ struct extirq_chip_data *chip_data;
+ int ret;
+
+ domain_parent = irq_find_host(parent);
+ if (!domain_parent) {
+ pr_err("interrupt-parent not found\n");
+ return -EINVAL;
+ }
+
+ chip_data = kzalloc(sizeof(*chip_data), GFP_KERNEL);
+ if (!chip_data)
+ return -ENOMEM;
+
+ chip_data->syscon = syscon_regmap_lookup_by_phandle(node, "syscon");
+ if (IS_ERR(chip_data->syscon)) {
+ ret = PTR_ERR(chip_data->syscon);
+ goto out_free_chip;
+ }
+
+ domain = irq_domain_add_hierarchy(domain_parent, 0, NIRQ, node,
+ &extirq_domain_ops, chip_data);
+ if (!domain) {
+ ret = -ENOMEM;
+ goto out_free_chip;
+ }
+
+ return 0;
+
+out_free_chip:
+ kfree(chip_data);
+ return ret;
+}
+
+IRQCHIP_DECLARE(ls1021a_extirq, "fsl,ls1021a-extirq", ls1021a_extirq_of_init);
--
2.7.4
\
 
 \ /
  Last update: 2017-12-08 15:33    [W:0.355 / U:0.088 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site