lkml.org 
[lkml]   [2017]   [Dec]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: pxa3xx_nand times out in 4.14 with JFFS2
On Sun, Dec 17, 2017 at 12:53:36PM -0300, Ezequiel Garcia wrote:
> If not too much to ask, this is the test that I believe is needed.
> You seem to have a setup ready, hence why I'm asking you, if
> possible, to give it a shot.
>
> (1) Scrub the BBT from the NAND. Or scrub the whole NAND.
> You cannot do this from the kernel, it needs to be done from the bootloader.
>
> (2) Mark a couple blocks as bad using the OOB -- AFAICR, there
> was a command to do this in the bootloader.
>
> (3) Boot, let Linux create the BBT and see if it catches the bad blocks.

Are the current boot loaders safe regarding the scrub operation ? I'm
asking because that's how I bricked my mirabox a few years ago when
trying to mark a bad block from u-boot :-/ If someone has a good
knowledge of these commands to limit the risk and helps me only playing
with a small part at the end of the flash (or in the unused area) I'd
prefer it :-)

> This would guarantee that devices with factory bad blocks,
> (and no BBT), would be OK with this patch.

I see. I'm fine with trying provided I have reasonably good assurance
that I won't have to go through the kwboot pain again :-/

Cheers,
Willy

\
 
 \ /
  Last update: 2017-12-17 17:25    [W:0.064 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site