lkml.org 
[lkml]   [2017]   [Nov]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: intel-gpio interrupts stop firing with Focaltech I2C-HID touchpad
On Fri, Nov 17, 2017 at 09:21:48PM +0800, Chris Chiu wrote:
> On Fri, Nov 17, 2017 at 7:00 PM, Mika Westerberg
> <mika.westerberg@linux.intel.com> wrote:
> > On Fri, Nov 17, 2017 at 06:01:27PM +0800, Chris Chiu wrote:
> >> Hi Mika,
> >> Here's the full dmesg log you need. The touchpad stop reporting at
> >> the last of the log.
> >> https://gist.github.com/mschiu77/a0b8d24a586a228c55eca30c87c71d41
> >
> > Thanks!
> >
> > I did not spot anything suspicious in the i2c-hid initialization. When
> > the issue happens, can you check what the pin state is and if it changes
> > when you use the touchpad? If I read your ACPI tables right, something
> > like this:
> >
> > # grep GPIO_18 /sys/kernel/debug/pinctrl/INT3452:00/pins
> >
> > (it could be another INT3452:* device as well).
> >
> > The GPIO line should be high and when the touchpad is pressed it should
> > go low.
> >
> > Then another thing, if you unload i2c-hid and load it back, does it
> > start working again?
> >
> > # modprobe -r i2c-hid
> > # modprobe i2c-hid
>
> Yup. We did the same inspection on /sys/kernel/debug/pinctrl/INT3452:00/pins
> before and after the touchpad stop working.
> Before touchpad stop working, most of the results would be
> pin 18 (GPIO_18) GPIO 0x40900102 0x00024075
> After touchpad stop working, the result would always be
> pin 18 (GPIO_18) GPIO 0x40900100 0x00024075

OK, so the line (as being active low) gets pulled to low and is never
released back.

Does /proc/interrupts show that the interrupt counts are still
increasing (for both the GPIO driver and the touchpad)?

\
 
 \ /
  Last update: 2017-11-17 17:19    [W:0.058 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site